Ozone Strong Water Dosing as Optimized Ozonation Process for Micropollutants Reduction in Wastewater Treatment Plants

K. F. Guerrero-Granados,Jan Mante,Midhun Joy,Markus Meier,Andrea Boergers,Stefan Panglisch,Jochen Tuerk

DOI: https://doi.org/10.1080/01919512.2024.2336973

2024-04-26

Ozone Science and Engineering

Abstract:Growing concern over potential ecotoxicological problems caused by micropollutants (MPs) in water has led to the application of adsorptive and oxidative advanced treatment technologies at European wastewater treatment plants (WWTPs). Direct dosage of gaseous ozone via diffusers or pump-injection systems is the most common large-scale process applied in water and wastewater treatment. Studies point out that MP removal may take place via the direct, very selective reaction with the ozone molecule as well as the indirect reaction with the very reactive but nonselective hydroxyl radicals. Several process parameters and set-ups may affect the MPs elimination and inhibit or even cause the formation of transformation products (TPs) such as bromate. This work compares an alternative ozone application procedure (the so-called 'ozone strong water' dosing – OSW) with standard systems regarding MP elimination, ozone consumption, reaction time, and required plant space. A full-scale OSW system was installed and operated at the WWTP Duisburg-Vierlinden. A significant reduction in the time required to achieve the maximum possible elimination was observed for all six MPs investigated, with a hydraulic reaction time of 8 min. According to a theoretical calculation, the reactor volume could be reduced by two-thirds of the installed volume.

environmental sciences,engineering, environmental

What problem does this paper attempt to address?

This paper discusses how to reduce the problem of micropollutants in wastewater treatment plants by optimizing the process of Ozone Strong Water Dosing (OSW). With increasing concerns about the ecotoxicological problems caused by micropollutants, advanced treatment technologies such as adsorption and oxidation are being adopted in European wastewater treatment plants. Ozone direct injection is the most common large-scale water treatment process, but the removal of micropollutants may occur through direct reaction with ozone molecules or indirect reaction with highly reactive but non-selective hydroxyl radicals.

The study compared the performance of the OSW system with the standard system in terms of micropollutant removal, ozone consumption, reaction time, and required facility space. A full-scale OSW system was installed and operated at the Duisburg-Vierlinden wastewater treatment plant, and the results showed that the OSW system significantly reduced the time required to achieve maximum removal for all six studied micropollutants, with a hydraulic reaction time of only 8 minutes. Theoretical calculations suggest that the reactor volume can be reduced to two-thirds of the existing volume.

The paper also discusses the challenges faced by ozone treatment, including high operating costs and the formation of transformation products, especially harmful substances such as bromate. The OSW system improves ozone dissolution and reaction efficiency by dividing the ozone injection process into three independent units, which is expected to reduce reactor volume, energy consumption, and production of transformation products.

The main objective of the study was to evaluate the micropollutant removal performance of the full-scale OSW system and compare it with the standard injection system. The experiments were conducted at the Duisburg-Vierlinden wastewater treatment plant, analyzing factors such as required space, removal efficiency of key micropollutants, time required to achieve maximum removal, and specific ozone dosage required to achieve an average removal rate of 80%. This is the first comprehensive-scale comparison of three different ozone injection programs in the same wastewater treatment plant.