Abstract:The European Organization for Nuclear Research (CERN) is one of the largest nuclear research centres in the world, operating the most powerful particle accelerator housed in a massive 80 km-long underground tunnel network. Over the decades, regular site inspection has observed the ongoing development of structural defects, such as widened cracks, water infiltration and misalignment of the particle accelerator beamline caused by differential tunnel floor settlements. Such ongoing tunnel deterioration necessitates long-term field monitoring and assessment of the continuous deformation behaviour of the tunnel lining. Recently, distributed fibre optic sensing (DFOS) has emerged as a promising tool for monitoring civil structures by providing spatially continuous strain measurements using fibre optic cables. Conventionally, a fibre optic cable can be continuously bonded onto a structure with a flat surface for continuous strain measurement (e.g., pile foundations, retaining walls). Nevertheless, to monitor tunnel circumferential movement, fibre optic cables usually can only be deployed at some discrete fixing points around a curved tunnel surface. The raw DFOS data obtained by this fixing-point method cannot be directly processed into continuous strain measurements due to the discrete nature of the installation. This poses a challenge for accurately analysing tunnel structural performance. To address the limitations of the fixing-point method, this paper presents an optimized data processing method for analysing DFOS strain measurements of curved circumferential tunnel behaviour at the CERN tunnel. The proposed method enables the determination of the actual stepwise strain profile between fixing points and its conversion into tunnel convergence by integrating along the path. The converted DFOS tunnel displacements offer a more realistic and intuitive representation of the tunnel deformation mode than the DFOS strain profile alone. Additionally, the results of tunnel displacement demonstrate agreement with convergence measurements obtained by the conventional total station method, indicating the enhanced capability of DFOS for existing tunnel monitoring and assessment. The DFOS method has the potential to provide highly accurate deformation measurements, with a much higher resolution than the typical measurement accuracy, for example, by total stations.

Method for Diagnosing the Uneven Settlement of a Rail Transit Tunnel Based on the Spatial Correlation of High-Density Strain Measurement Points

Principles and Application of a Smart Tunnel Laser Convergence Gauge for Monitoring Tunnel Crown Settlement

Probabilistic Assessment of Tunnel Convergence Considering Spatial Variability in Rock Mass Properties Using Interpolated Autocorrelation and Response Surface Method

Method For Tunnel Life-Cycle Heath Monitoring Based On Distributed Optical Fiber Sensor

Vibration of different types of tracks of subway in soft soil

Method for Tunnel Displacements Calculation Based on Mobile Tunnel Monitoring System

Study of sections strain of undersea immersed tube tunnel based on optical fiber grating technology

Condition Diagnosis of Long-Span Bridge Pile Foundations Based on the Spatial Correlation of High-Density Strain Measurement Points

Prediction Methods on Tunnel-Excavation Induced Surface Settlement Around Adjacent Building

Application of Long Distance Fiber Sensing Technique in Metro Tunnel Monitoring

Complex Deformation Monitoring of Shield Tunnel Segment Joints Using Distributed Fiber Optic Sensing Technology: Experimental Verification

Simultaneous Measurement of Strain and Displacement for Railway Tunnel Lining Safety Monitoring

Distributed Fibre Optic Sensing and Novel Data Processing Method for Tunnel Circumferential Deformation – A Case Study of an Ageing Tunnel at CERN

Deformation monitoring at shield tunnel joints: Laboratory test and discrete element simulation

Tunnel Monitoring and Measuring System Using Mobile Laser Scanning: Design and Deployment

Review on monitoring and prediction of uneven settlement of track foundation

Systematic Approach for Tunnel Deformation Monitoring with Terrestrial Laser Scanning

Theoretical, Numerical, and Experimental Study on the Identification of Subway Tunnel Structural Damage Based on the Moving Train Dynamic Response

Experimental Test of Ground Settlement Measurement Using Distributed Fiber Optic Sensing Technology

Deformation Monitoring of Metro Tunnel with a New Ultrasonic-Based System

Study on InSAR deformation information extraction and stress state assessment in a railway tunnel in a plateau area