Abstract:The rotating blade is a key turbomachinery component with a high failure risk. Therefore, monitoring the rotating blade is urgently required. Blade tip timing (BTT) is regarded as an efficient technique for blade vibration monitoring as it reflects the condition of blades. However, the identification process from under-sampled data and probe layout optimization hinder the application of BTT. Most of the existing parameter identification methods have strict probe layout requirements; thus, an inappropriate probe layout may fail BTT measurements. An increased number of probes and optimal probe positions are considered essential for frequency identification. However, an optimal probe layout is usually restricted by arrangement. In this work, a novel frequency identification method via a single BTT probe is proposed by considering arrangement, cost, and safety restrictions. The proposed method focuses on the relationship between sampling and aliasing frequencies, which can be summarized in two steps: obtaining a Sampling–Aliasing Frequency (SAFE) map and identifying the resonance center and corresponding engine order (EO). Obtaining the SAFE map of the BTT signal recorded by a single probe is difficult because of low and variable sampling frequency. To overcome this problem, the adaptive window length short-time Fourier transform is proposed. Based on the SAFE and EO, the natural frequency can be accurately extracted from a single BTT measurement. Uniformly and nonuniformly variable speed conditions were investigated, and the results were compared with those obtained using multiple probes. The proposed method has been verified to provide blade natural frequency from a single-probe BTT measurement.

Rotating blade frequency identification by single-probe blade tip timing

Spatial Transformation of General Sampling-Aliasing Frequency Region for Rotating-Blade Parameter Identification with Emphasis on Single-Probe Blade Tip-Timing Measurement

Biprobes Blade Tip Timing Method for Frequency Identification Based on Active Aliasing Time-Delay Estimation and Dealiasing.

A New Method for Non-Uniform Under-Sampled Blade Tip Timing Signal Reconstruction

OPR-free Single Probe Blade Tip Timing for Monitoring Rotating Blade

Frequency Identification Method Based on Active Aliasing of Biprobes Blade Tip Timing Without Once-Per-revolution

A Single-Probe Blade Tip Timing Method for Fast Extraction of Blade Natural Frequency

Single-Probe Blade Tip Timing: A Novel Method for Anomaly Identification Based on Frequency Shift.

High-resolution sampling aliasing frequency distribution

Active Aliasing Technique and Risk Versus Error Mechanism in Blade Tip Timing

An OPR-Free Blade Tip Timing Method for Rotating Blade Condition Monitoring

Parameter Identification Based on Iterative Signal Space in Blade Tip Timing

An Improved Key-Phase-Free Blade Tip-Timing Technique for Nonstationary Test Conditions and Its Application on Large-Scale Centrifugal Compressor Blades

Blade Tip Timing Signal Filtering Method Based on Sampling Aliasing Frequency Map

Parametric Bayesian Model for Rotating Blade Frequency Tracking with Single Probe Blade Tip Timing

Sampling Aliasing Frquency Distribution: Therory, Implementation, and Applicaiton

Phase-offset-based Synchronous Resonance Identification Method for Blade Tip Timing Signal

Measurement Methodology: Blade Tip Timing: A Non-Contact Blade Vibration Measurement Method

Blade Tip Timing: from Raw Data to Parameters Identification

A blade tip-timing method without once-per-revolution sensor for blade vibration measurement in gas turbine engines

Sparse Representation Based Frequency Detection and Uncertainty Reduction in Blade Tip Timing Measurement for Multi-Mode Blade Vibration Monitoring