Abstract:The radial and axial vibration signals of a rotating machine are crucial information to understand the machine operation and to diagnose potential faults. Instead of using three single sensors to measure the horizontal, vertical and axial displacements of rotating shafts, a novel non-projection vision-based system was proposed to realize simultaneous measurement of the radial and axial displacements with high accuracy and good reliability using an tailored artificial constant density sinusoidal fringe pattern (CDSFP), which was pasted around the shaft surface and worked as a tri-axial (i.e. the horizontal, vertical and axial) displacement sensor. The measurement principle and setup of the proposed measurement system were well established. The horizontal displacement could be correctly obtained from the fringe period density changes of the CDSFP image sequence recorded by a high-speed camera. Simultaneously, the vertical displacement could be acquired by tracking the centerline of shaft whilst the axial displacement could be obtained by locating the peaks of the cross-correlation sequence of the fringe intensities. A sub-pixel method was employed to improve the displacement resolution of the developed system. The performance of the proposed system was demonstrated by the comparison of the experiments using eddy current sensors. It showed that the proposed method was an effective and accurate technique for real-time tri-axial vibration monitoring of rotating shaft. Experimental results verified the feasibility, effectiveness and good robustness of the proposed methodology, which demonstrated that the proposed system was capable of achieving accurate tri-axial vibration displacements of rotating shaft compared to the commercial eddy current sensor which could only measure one dimensional displacement at each measurement. Therefore, the vision-based tri-axial vibration monitoring system could be recommended for real engineering applications in condition monitoring of rotating shafts. (C) 2018 Elsevier Ltd. All rights reserved.

Single-sensor rotating blade monitoring method under non-stationary conditions based on velocity and displacement

Analysis of Vibration Monitoring Data of an Onshore Wind Turbine under Different Operational Conditions

An Improved Key-Phase-Free Blade Tip-Timing Technique for Nonstationary Test Conditions and Its Application on Large-Scale Centrifugal Compressor Blades

A New Method for Non-Uniform Under-Sampled Blade Tip Timing Signal Reconstruction

A method of in-situ monitoring multiple parameters and blade condition of turbomachinery by using a single acoustic pressure sensor

Variational Bayesian Modal Composition Beamforming for Fast-Rotating Axial-Fan Blade-Noise Localization and Its Application Condition

A Fast Bayesian High-Resolution Localization Method for Rotating Blade Noise

Improved Blade Tip Timing in Blade Vibration Monitoring with Torsional Vibration of the Rotor

Research on Vibration Characteristics of Last Stage Blade Based on Blade Tip-Timing Technology

Research on Detecting Technology of Rotating Blade Vibration Performance Parameters

A Single-Probe Blade Tip Timing Method for Fast Extraction of Blade Natural Frequency

Non-contact Rotor Vibration Velocity Sensor and Its Application to Vibration Control of a Flexible Rotor on Active Magnetic Bearings

A novel rotor dynamic balancing method based on blade tip clearance measurement without the once per revolution sensor

Rotating blade frequency identification by single-probe blade tip timing

Sparse Representation Based Frequency Detection and Uncertainty Reduction in Blade Tip Timing Measurement for Multi-Mode Blade Vibration Monitoring

High-resolution sampling aliasing frequency distribution

Structural Health Monitoring of Wind Turbine Blade Using Fiber Bragg Grating Sensors and Fiber Optic Rotary Joint

A Novel Method to Improve the Precision of BTT under Rapid Speed Fluctuation Conditions

Real-time Three-Dimensional Vibration Monitoring of Rotating Shafts Using Constant-Density Sinusoidal Fringe Pattern As Tri-Axial Sensor

Blade damage monitoring method base on frequency domain statistical index of shaft’s random vibration

Measurement And Analysis Of Vibration And Noise Signals Of Rotating Machines By Non-Invasive Method