Abstract:The glycerol generated as a by-product in the production of biodiesel could be used as a renewable raw material to economically promote the production process. The catalytic conversion of glycerol to a product with higher added value, such as glycerol carbonate, has attracted great interest in the chemical, pharmaceutical, and lithium battery industries, among others, due to its low toxicity, hydration capacity, and biodegradability. Layered-double hydroxide (LDH) materials, the precursors of the catalysts, were synthesized by a direct coprecipitation method to incorporate a third metal ion in addition to magnesium and aluminum ions. This method is the easiest regularly applied technique to design these low cost anionic nanoclay. The atomic percentage of Cu, Zn, or Ni incorporated was 15% of the Mg load in the material. The synthesis atomic ratio, (M 2+ +Mg 2+ )/Al 3+ had a constant value of 3, where M represents the transition metal incorporated. LDHs produced the corresponding mixed metal oxides by thermal decomposition. These materials have excellent properties for reactions catalyzed by the basic sites, high surface area, homogeneous cation dispersion, and thermal stability. The physicochemical material properties were characterized by XRD, N 2 sorption, MP-AES, TPD-CO 2 , SEM, and XPS. The mixed oxides were evaluated in the catalytic conversion of glycerol to glycerol carbonate. The addition of Cu, Ni, or Zn to the matrix of Mg and Al produced changes in its physicochemical properties and mostly in the catalytic activity. X-ray diffractograms of LDHs showed the typical characteristic structure of layers even with metallic ions of Cu, Ni, or Zn incorporated, because their ionic radii are similar to that of the Mg ion, 0.69, 0.73, and 0.74 Å, respectively. The obtained mixed oxides showed a high catalytic activity towards the conversion of glycerol to glycerol carbonate under mild reaction conditions, a 1:2 ratio of glycerol:ethylene carbonate and solvent free. Relative yields higher than 80% were obtained, attributable to an adequate distribution of basicity and textural parameters. The catalysts were used in successive reaction cycles without significant loss of activity.

Studies on Mg-Ba mixed oxide catalyst for continuous glycerol transesterification to glycerol carbonate

Tuning catalytic performance: comparative study of magnesium–strontium mixed oxide catalysts for glycerol carbonate synthesis

Structural study of mixed metal oxide catalysts comprising Mg, Ca, and Al used for upgrading biodiesel byproduct glycerol to glycerol carbonate

Catalytic Conversion of Sugars to Methyl Lactate over Mg-MOF-74 in Near-Critical Methanol Solutions

Mg–Al Mixed Oxide Derived from Hydrotalcites Prepared Using the Solvent-Free Method: A Stable Acid–Base Bifunctional Catalyst for Continuous-Flow Transesterification of Dimethyl Carbonate and Ethanol

Synthesis of glycerol carbonate using Li/Mg/K modified zeolite beta: a kinetic study

Oligomerization of glycerol on layered sodium silicate catalysts

Mixed oxides from calcined layered double hydroxides for glycerol carbonate production to contribute to the biodiesel economy

Catalytic Performance of Li/Mg Composites for the Synthesis of Glycerol Carbonate from Glycerol and Dimethyl Carbonate

Etherification of glycerol into short-chain polyglycerols over MgAl LDH/CaCO3 nanocomposites as heterogeneous catalysts to promote circular bioeconomy

Transesterification of Glycerol to Glycerol Carbonate over Mg-Zr Composite Oxide Prepared by Hydrothermal Process

Layered double hydroxides modified by transition metals for sustainable glycerol valorization to glycerol carbonate

Comparative study of catalytic conversion of glycerol, a by-product of transesterification, to cyclic hydrocarbons using MCM-22, ZSM-5 and alumina

Fabrication of hierarchically porous MgO with high surface area and adjustable alkalinity for efficient transesterification synthesis of ethyl methyl carbonate

Selective Hydrogenolysis of Glycerol to Propylene Glycol on MgO-Al2O3Dispersed Cu Catalysts

Excess soluble alkalis to prepare highly efficient MgO with relative low surface oxygen content applied in DMC synthesis

Production of glycerol carbonate from glycerol and carbon dioxide using metal oxide catalysts

Transesterification of glycerol with dimethyl carbonate over Mg-Al hydrotalcites

Biodiesel Production Using MgO–CaO Catalysts via Transesterification of Soybean Oil: Effect of MgO Addition and Insights of Catalyst Deactivation

The Influence of Si/Al Ratio on the Physicochemical and Catalytic Properties of MgO/ZSM-5 Catalyst in Transesterification Reaction of Rapeseed Oil

BaO as a heterogeneous nanoparticle catalyst in oil transesterification for the production of FAME fuel