Abstract:Flexoelectric material under certain inhomogeneous electric field can be utilized to control the vibration of flexible structure based on the converse flexoelectric effect. The atomic force microscope (AFM) probe placed on the top of flexoelectric patch and the electrode under it with certain voltage applied between them are used to generate the inhomogeneous electric field. The actuation membrane force and bending moment induced by flexoelectric patch in turn influence the vibration of shells. In this study, an elastic cantilever beam excited by an initial static mechanical force locating at the tip end is considered. As the mechanical force withdraws the snapback response appears where the cantilever beam vibrates with all mode participating and their amplitudes decaying exponentially. Multiple actuators, consist of AFM probes and flexoelectric patches, are used here to accelerate the decrease of snapback response. On each probe voltages of multiple frequencies are applied to obtain the control effects on multiple modes. The actuator’s positions minimizing the tip displacement of the beam is selected as the optimal ones. Two way of determining the control voltage, i.e., open loop and close loop, is introduced and the information of positions of the actuators are emphasized in both methods. In case studies, the free damping vibration of the beam without control is evaluated and the first mode dominates the vibration. The open loop method, with constant amplitude of control voltage, doesn’t work well in a relatively long time scale. While the close loop method, with its control voltage related to the tip displacement detected by a sensor, turns out to be more stable and effective. The optimal positions for the actuations of both methods are clustered near the fixed end, where the actuation factor reaches its maximal value. At last, limitation on voltage amplitude is implemented to avoid the stress concentration, under which the control effect does not weaken much. This study serves as an introduction to flexoelectric material & multiple AFM probe based vibration control and a theoretical foundation for further researches.

Improved active vibration control of a cantilever beam using MFC actuators with Hammerstein model-based hysteresis modeling and VSS-FxLMS control algorithm

Active Vibration Control of Flexible Structures with Super-Coiled Actuators

Rate-Dependent Hysteresis Modeling and Displacement Tracking Control Based on Least-Squares SVM for Axially Pre-Compressed Macro-Fiber Composite Bimorph.

Active Vibration Control of Composite Cantilever Beams

Vibration Suppression of a High-Speed Macro-Micro Integrated System Using Computational Optimal Control

Modeling and active control of geometrically nonlinear vibration of composite laminates with macro fiber composite

Stochastic Vibration Suppression Analysis of an Optimal Bounded Controlled Sandwich Beam with MR Visco-Elastomer Core

Simulation and Experiment of Active Vibration Control Based on Flexible Piezoelectric MFC Composed of PZT and PI Layer

Adaptive iterative learning control and inverse compensation of macro fiber composite system with hysteresis

Active Damping Control of the Large-scale Flexible Hydraulic Manipulators with Independent Metering System

Control of Beam’s Snapback Responses Using Multiple Flexoelectric Actuators

Multiflexoelectric Actuation and Control of Beams

Flexoelectric Control of Beams with Atomic Force Microscope Probe Excitation

The Active Vibration Attenuation of A Built-In Motorized Milling Spindle

Active Damping Control of the Large-scaleFlexible Hydraulic Manipulators Withindependent Metering System

An optimal vibration control strategy of AMB-flexible rotor syxstem

Adaptive active vibration control for composite laminated plate: Theory and experiments

Active vibration optimal control of piezoelectric cantilever beam with uncertainties

Active vibration control of a flexible beam based on experimental modal analysis

Experimental investigation on rate-dependent vibration control of giant magnetostrictive actuators

Active vibration control and optimal position of MFC actuator for the bistable laminates with four points simply support