Abstract:Flexoelectric material under certain inhomogeneous electric field can be utilized to control the vibration of flexible structure based on the converse flexoelectric effect. The atomic force microscope (AFM) probe placed on the top of flexoelectric patch and the electrode under it with certain voltage applied between them are used to generate the inhomogeneous electric field. The actuation membrane force and bending moment induced by flexoelectric patch in turn influence the vibration of shells. In this study, an elastic cantilever beam excited by an initial static mechanical force locating at the tip end is considered. As the mechanical force withdraws the snapback response appears where the cantilever beam vibrates with all mode participating and their amplitudes decaying exponentially. Multiple actuators, consist of AFM probes and flexoelectric patches, are used here to accelerate the decrease of snapback response. On each probe voltages of multiple frequencies are applied to obtain the control effects on multiple modes. The actuator’s positions minimizing the tip displacement of the beam is selected as the optimal ones. Two way of determining the control voltage, i.e., open loop and close loop, is introduced and the information of positions of the actuators are emphasized in both methods. In case studies, the free damping vibration of the beam without control is evaluated and the first mode dominates the vibration. The open loop method, with constant amplitude of control voltage, doesn’t work well in a relatively long time scale. While the close loop method, with its control voltage related to the tip displacement detected by a sensor, turns out to be more stable and effective. The optimal positions for the actuations of both methods are clustered near the fixed end, where the actuation factor reaches its maximal value. At last, limitation on voltage amplitude is implemented to avoid the stress concentration, under which the control effect does not weaken much. This study serves as an introduction to flexoelectric material & multiple AFM probe based vibration control and a theoretical foundation for further researches.

Active vibration control and optimal position of MFC actuator for the bistable laminates with four points simply support

Stochastic Vibration Suppression Analysis of an Optimal Bounded Controlled Sandwich Beam with MR Visco-Elastomer Core

Adaptive active vibration control for composite laminated plate: Theory and experiments

Nonlinear Dynamic and Piezoelectric Ply Control Strategies Investigations on Laminated Flexible Spacecraft

Modeling and active control of geometrically nonlinear vibration of composite laminates with macro fiber composite

Active vibration control of basic structures using macro fiber composites

Simulation and Experiment of Active Vibration Control Based on Flexible Piezoelectric MFC Composed of PZT and PI Layer

Active Control of Honeycomb Sandwich Plate Using MFC Piezoelectric Actuators

Control of Beam’s Snapback Responses Using Multiple Flexoelectric Actuators

Active Vibration Control Based on Piezoelectric Smart Composite

Multiflexoelectric Actuation and Control of Beams

Improved active vibration control of a cantilever beam using MFC actuators with Hammerstein model-based hysteresis modeling and VSS-FxLMS control algorithm

Active Vibration Control of Composite Cantilever Beams

Active control of functionally graded laminated cylindrical shells

Modeling and Vibration Control of Sandwich Composite Plates

Finite Element Modeling and Vibration Control of Plates with Active Constrained Layer Damping Treatment

Active Vibration Damping of Composite Beam Using Smart Sensors and Actuators

Active Vibration Control of Piezoelectric Sandwich Plates

Vibration control with the converse flexoelectric effect on the laminated beams

Active Vibration Control of a Doubly Curved Composite Shell Stiffened by Beams Bonded With Discrete Macro Fiber Composite Sensor/Actuator Pairs

Optimal Vibration Control of Membrane Structures with In-Plane Polyvinylidene Fluoride Actuators