Abstract:Neutron time-of-flight (nTOF) detectors are crucial in diagnosing the performance of inertial confinement fusion (ICF) experiments, which implode targets of deuterium-tritium fuel to achieve thermonuclear conditions. These detectors utilize the fusion neutron energy spectrum to extract key measurements, including the hotspot ion temperature and fuel areal density. Previous work [Danly et al., Rev. Sci. Instrum. 94, 043502 (2023)] has demonstrated adding 1D spatial resolution to an nTOF-like detector using a neutron aperture and streak camera to measure the ion temperature profile of an ICF implosion. By contrast, the study presented herein explores modifying the 1D detector to use a fast photomultiplier tube (PMT) to validate the design of a 2D spatially resolved instrument based on reconstruction from 1D profiles. The modification would collect time-of-flight traces from separate scintillators in an imaging array with one PMT using optical fibers of varying lengths to time-multiplex the signals. This technique has been demonstrated in ride-along experiments on the OMEGA laser with 20 fiber-coupled scintillator channels connected to a Photek PMT210. Results provide constraints on the fiber lengths and PMT gating requirements to promote pulse fidelity throughout all channels. Calibration of the detector to fixed nTOFs can provide a preliminary estimate of the instrument response function (IRF), although measurement of the IRF is currently under way. These results suggest that nTOF signals can potentially be time-multiplexed with fibers so long as the design is strategic to mitigate signal-to-noise reduction, modal dispersion, and charge build-up in the PMT, which has implications beyond ion temperature imaging.

Simultaneous analysis of collinear neutron time-of-flight (nToF) traces applied to pulsed fusion experiment

Optically multiplexed neutron time-of-flight technique for inertial confinement fusion

Recent highlights and prospects on (n,$γ$) measurements at the CERN n_TOF facility

TOF spectroscopy measurement using waveform digitizer

Neutron Time-Of-Flight Spectroscopy Measurement Using A Waveform Digitizer

Data Acquisition System with Pulse Height Capability for the Tofed Time-Of-Flight Neutron Spectrometer

Second Generation Fusion Neutron Time-of-flight Spectrometer at Optimized Rate for Fully Digital Data Acquisition.

Diagnosing up-scattered deuterium–tritium fusion neutrons produced in burning plasmas at the National Ignition Facility (invited)

Technique for Measuring Angular Correlations and G-Factors of Excited States with Large Multi-Detector Arrays: an Application to Neutron Rich Nuclei Produced by the Spontaneous Fission of 252Cf

1H(n,el) as a Cross Section Reference in a White Source Neutron Beam With the fissionTPC

Investigation Of Fast Neutron Resonance Transmission Analysis Based On The Ultrashort Pulsed Electron Beam-Driven Photoneutron Source

TOF Spectroscopy Measurement with Waveform Digitizer at TMSR Photoneutron Source

Diagnosing NB Plasmas on the EAST Tokamak with New Time-of-flight Neutron Spectrometer

A Data Analysis Method for Isochronous Mass Spectrometry Using Two Time-Of-Flight Detectors at Csre

Neutron Induced Fission Fragment Angular Distributions, Anisotropy, and Linear Momentum Transfer Measured with the NIFFTE Fission Time Projection Chamber

High resolution measurement of tagged two-neutron energy and angle correlations in Cf-252(sf)

Real-time Source Localisation by Passive, Fast-Neutron Time-of-flight with Organic Scintillators for Facility-Installed Applications

Simultaneous Measurement of the HT and DT Fusion Burn Histories in Inertial Fusion Implosions

Measurement and analysis of the $^{246}$Cm and $^{248}$Cm neutron capture cross-sections at the EAR2 of the n TOF facility

Determination of fast neutron spectrum using recoil-proton track imaging method

Measurement and Simulation of the Response Function of Time of Flight Enhanced Diagnostics Neutron Spectrometer for Beam Ion Studies at EAST Tokamak.