Abstract:The neutron time-of-flight (n_TOF) facility at the European Laboratory for Particle Physics (CERN) is a pulsed white-spectrum neutron spallation source producing neutrons for two experimental areas: the Experimental Area 1 (EAR1), located 185 m horizontally from the target, and the Experimental Area 2 (EAR2), located 20 m above the target. The target, based on pure lead, is impacted by a high-intensity 20−GeV/c pulsed proton beam. The facility was conceived to study neutron-nucleus interactions for neutron kinetic energies between a few meV to several GeV, with applications of interest for nuclear astrophysics, nuclear technology, and medical research. After the second-generation target reached the end of its lifetime, the facility underwent a major upgrade during CERN's Long Shutdown 2 (LS2, 2019–2021), which included the installation of the new third-generation neutron target. The first- and second-generation targets were based on water-cooled massive lead blocks and were designed focusing on EAR1, since EAR2 was built later. The new target is cooled by nitrogen gas to avoid erosion-corrosion and contamination of cooling water with radioactive lead spallation products. Moreover, the new design is optimized also for the vertical flight path and EAR2. This paper presents an overview of the target design focused on both physics and thermomechanical performance, and includes a description of the nitrogen cooling circuit and radiation protection studies. https://doi.org/10.1103/PhysRevAccelBeams.24.093001 Published by the American Physical Society under the terms of the Creative Commons Attribution 4.0 International license. Further distribution of this work must maintain attribution to the author(s) and the published article's title, journal citation, and DOI. Published by the American Physical Society

New perspectives for neutron capture measurements in the upgraded CERN-n_TOF Facility

Recent highlights and prospects on (n,$γ$) measurements at the CERN n_TOF facility

The neutron time-of-flight facility n_TOF at CERN Recent facility upgrades and detector developments

New detection systems for an enhanced sensitivity in key stellar (n,$γ$) measurements

Design of the third-generation lead-based neutron spallation target for the neutron time-of-flight facility at CERN

Measurement and analysis of the $^{246}$Cm and $^{248}$Cm neutron capture cross-sections at the EAR2 of the n TOF facility

The new Cold Neutron Chopper Spectrometer at the Spallation Neutron Source - Design and Performance

Towards a new generation of solid total-energy detectors for neutron-capture time-of-flight experiments with intense neutron beams

Designing an upgrade of the Medley setup for light-ion production and fission cross-section measurements

Innovative approaches to neutron beam optimization: A case study of FP14 at LANSCE

New perspectives for neutron imaging through advanced event-mode data acquisition

Characterization of the FOOT neutron detectors for nuclear fragmentation measurements at the n_TOF facility

Pushing the high count rate limits of scintillation detectors for challenging neutron-capture experiments

Optically multiplexed neutron time-of-flight technique for inertial confinement fusion

Coherent Elastic Neutrino-Nucleus Scattering at the European Spallation Source

Determining the nuclear neutron distribution from Coherent Elastic neutrino-Nucleus Scattering: current results and future prospects

In-beam test results of an RPC-based module for position-sensitive neutron detectors with timing readout

Simultaneous analysis of collinear neutron time-of-flight (nToF) traces applied to pulsed fusion experiment

Neutron Measurements from Beam-Target Reactions at the Elise Neutral Beam Test Facility

Disentangling time-focusing from beam divergence: a novel approach for high-flux thermal neutron spectroscopy at continuous and long-pulse sources

A Segmented Total Energy Detector (sTED) optimized for (n, γ ) cross-section measurements at n_TOF EAR2