Abstract:This study developed three composite slurries for coating recycled aggregate by incorporating polyacrylate emulsion, fly ash, and gypsum into a cement-based mixture. The filling and pozzolanic effects of fly ash help to improve microcracks in the recycled aggregates. The polyacrylate emulsion forms a strong bonding layer between the cement matrix and the aggregates, enhancing the interfacial bond strength. Based on relevant studies, the following mix designs were developed: Slurry 1 consists of pure cement paste; Slurry 2 contains 15% fly ash and 3% gypsum added to the cement paste; Slurry 3 adds 22% polyacrylate emulsion to the slurry. The study first compared the effects of the three composite slurries on the crushing value and water absorption of recycled aggregates, and then analyzed their impact on the mechanical properties, permeability, and drying shrinkage of concrete. Finally, the mechanisms behind the enhancement were investigated using the Vickers Hardness Test (HV), Mercury Intrusion Porosimetry (MIP), and scanning electron microscopy–energy-dispersive spectroscopy (SEM-EDS). The results showed that the polyacrylate emulsion composite slurry had the most significant improvement effect. For recycled aggregate AL, the crushing value decreased from 28.8% to 22.5% and the saturated surface–dry water absorption decreased from 15.1% to 13.8% after cement slurry modification. After coating with the composite slurry, the crushing value further dropped to 18.2% and the water absorption to 9.5%. Two aspects of the performance of recycled aggregates are enhanced with the polymer composite slurry: first, fly ash provides nucleation sites for CH, reducing the tendency for directional CH alignment. Second, the long chains of PAE (polyacrylic ester) encapsulate cementitious particles, effectively filling surface defects on the recycled aggregates, improving the bonding strength at the new-to-old interface, and significantly enhancing the performance of both recycled aggregates and recycled concrete.

Investigation of Adhered Mortar Content on Recycled Aggregate Using Image Analysis Method

Mortar with Substituted Recycled PET Powder: Experimental Characterization and Data-Driven Strength Predictive Models

Quantitative Analysis of Surface Attached Mortar for Recycled Coarse Aggregate

Methods for Determination of Residual Mortar Content Adhered to Recycled Aggregate

Analysis of the influence of the attached mortar's geometry on the mechanical behaviour of recycled aggregate concrete through mesoscale modelling

Experimental Research on the Mechanical Properties of Recycled Aggregate Particle Gradation and Addition on Modified Cement Soil

Characterization of sustainable mortar containing high-quality recycled manufactured sand crushed from recycled coarse aggregate

An evaluation of the recycled aggregate characteristics and the recycled aggregate concrete mechanical properties

Effects of varied building solid wastes, particle sizes and substitution ratios on the performance and impedance spectrum of recycled fine aggregate mortar and the feasibility of developing a prediction method

Improvement of recycled aggregate properties through a combined method of mechanical grinding and microbial-induced carbonate precipitation

Effect of the Fine Recycled Aggregates on the Dynamic Compressive Behavior of Recycled Mortar

Microstructural Analysis of Recycled Aggregate Produced from Nano-Enhancement Approach

Effect of the incorporation ratio of recycled concrete aggregate on the properties of self-compacting mortar

Effect of Mixed Recycled Aggregate on the Mechanical Strength and Microstructure of Concrete under Different Water Cement Ratios

Effects of pretreated recycled fine aggregates on the mechanical properties and microstructure of alkali-activated mortar

Understanding the behavior of recycled aggregate concrete by using thermogravimetric analysis

A Mechanical Treatment Method for Recycled Aggregates and Its Effect on Recycled Aggregate-Based Concrete

Using recycled aggregate and powder from high-strength mortar waste for durable cement-based materials: Microstructure and chloride transport

Pore size distribution and ITZ performance of mortars prepared with different bio-deposition approaches for the treatment of recycled concrete aggregate

Analysis of the Impact and Mechanism of Polyacrylate-Based Composite Paste on the Performance of Recycled Aggregate

Numerical Simulation of Water Transport in Unsaturated Recycled Aggregate Concrete