Abstract:Fly ash, lithium slag and steel slag as industrial waste, replace quality cement to prepare cement mortar and concrete, but its utilization is often low, so using these industrial waste in large quantities by using X-ray diffraction (XRD), thermal analyzer, Fourier infrared spectrometer and scanning electron microscope analysis method, we studied the hydration products, spectral performance and microstructure of mortar after mineral admixtures as fine aggregate, and the change laws of mortar strength with the replacement rate (0%, 30%, 50%, 70% and 100%) were analyzed. Test results showed that the hydration products were CSH gel, Ca(OH)(2), a small amount of AFt and Four kinds of slurry hydration products mainly for CSH gel, Ca(OH)(2), a small amount of AFt and unhydrated particles (Al2O3 and SiO2) for cement paste, cement-lithium slag paste, cement-fly ash paste, cement-steel slag paste, which contain a certain Li2O center dot Al2O3 center dot SiO2, Ca1.56SiO3.5 center dot xH(2)O, and RO phase, respectively. Characteristic peak was 3 467, 3 438, 2 923, 2 348, 1 638, 1 429, 1 111, 1 000, 768, 696 and 462 cm(-1) for four paste, but its strong peak was different and activity was also different, which was involved in the level of secondary hydration reaction is also different, so the content of Ca(OH)(2) in cement-steel slag paste was significantly higher than cement-lithium slag paste and cement-fly ash paste. It played volcanic activity and filling effect when mineral admixtures replaced cement or fine aggregate. The flexural strength and compressive strength of mortar with 100% mineral admixture (lithium slag, fly ash and steel slag) were higher than pure cement mortar, it was about 37. 77%/51. 88%, 14. 71%/11. 70%, 14. 71%/34. 88%, respectively, But the flexural strength and compressive strength reached the maximum when the dosage of mineral admixtures was different. Therefore, mineral admixtures as fine aggregate of mortar were feasible, which can greatly improve the use of industrial waste in the concrete industry, and can achieve the result of energy conservation and emissions reduction.

Using recycled aggregate and powder from high-strength mortar waste for durable cement-based materials: Microstructure and chloride transport

Mortar with Substituted Recycled PET Powder: Experimental Characterization and Data-Driven Strength Predictive Models

Chloride diffusion and binding capacity of sustainable cementitious materials with construction waste powder as cement replacement

Experimental Study on the Strength and Hydration Products of Cement Mortar with Hybrid Recycled Powders Based Industrial-Construction Residue Cement Stabilization of Crushed Aggregate

Characterization of sustainable mortar containing high-quality recycled manufactured sand crushed from recycled coarse aggregate

Compound utilization of construction and industrial waste as cementitious recycled powder in mortar

Sustainable Cement Mortar with Recycled Plastics Enabled by the Matrix-Aggregate Compatibility Improvement

Five-phase Modelling for Effective Diffusion Coefficient of Chlorides in Recycled Concrete

Rheological and early hydration of cementitious material containing recycled concrete powders collected from recycled aggregates

Reusing Waste Concrete Recycled Powder in Mortar: Paste Substitution versus Cement Substitution

Role of recycled concrete powder as sand replacement in the properties of cement mortar

Recycling of the end-of-life lightweight aggregate concrete (LWAC) with a novel approach

Effect of Mixed Recycled Aggregate on the Mechanical Strength and Microstructure of Concrete under Different Water Cement Ratios

Effects of varied building solid wastes, particle sizes and substitution ratios on the performance and impedance spectrum of recycled fine aggregate mortar and the feasibility of developing a prediction method

Micro-macro characterizations of mortar containing construction waste fines as replacement of cement and sand: A comparative study

Stuay of Mineral Admixtures as Fine Aggregate on Hydration Products and Spectral Performance of Mortar

Using Eco-Friendly Recycled Powder from CDW to Prepare Strain Hardening Cementitious Composites (SHCC) and Properties Determination

Development of Sustainable Cement-Based Materials with Ultra-High Content of Waste Concrete Powder: Properties and Improvement

Recycled Aggregates Influence on the Mechanical Properties of Cement Lime-Based Mortars

Properties and CO2-curing enhancement of cement-based materials containing various sources of waste hardened cement paste powder

Experimental study on mechanical property and microstructure of cement mortar reinforced with elaborately recycled GFRP fiber