Theoretical Foundations and Experimental Results

Alexey Sobisevich,Dmitriy Presnov,Andrey Shurup
DOI: https://doi.org/10.3390/jmse12071060
IF: 2.744
2024-06-25
Journal of Marine Science and Engineering
Abstract:The results of theoretical analysis and practical implementation of seismoacoustic methods developed for monitoring ice-covered regions in the Arctic are presented and discussed. Special attention is paid to passive seismoacoustic tomography as a unique method of studying the deep structure of the lithosphere and hydrosphere without the use of powerful sources. One of the distinctive features of the considered approach is the use of receivers located on the ice surface to recover characteristics of Arctic-type seismoacoustic waveguide "lithosphere-hydrosphere-ice cover". In passive monitoring, special attention is paid to reducing the noise signal accumulation time required to obtain seismoacoustic wave propagation times, as well as expanding the analyzed frequency bandwidth. The presented results can be used to develop technologies for seasonal and long-term monitoring of the currently observed variability of large areas of the Arctic region due to climatic changes.
oceanography,engineering, marine, ocean
What problem does this paper attempt to address?
The problem that this paper attempts to solve is the technical challenges of using passive seismo - acoustic tomography technology for environmental monitoring in the Arctic ice - covered area. Specifically, the research aims to: 1. **Develop seismo - acoustic monitoring methods applicable to the Arctic ice - covered area**: Through analysis and experimental verification, the research proposes a method of using sensors installed on the ice surface to monitor the special seismo - acoustic waveguide of "lithosphere - hydrosphere - ice sheet". This method can be used to monitor the seasonal and long - term changes in large - area ice - covered waters, especially those caused by climate change. 2. **Identify wave types that can be used to monitor the Arctic environment**: The research explores which types of waves can be monitored by seismo - acoustic sensors under Arctic conditions. These waves include flexural - gravity waves, bottom - surface waves (similar to Rayleigh waves on land), Lamb modes in the ice layer, and underwater acoustic modes. Particular attention is paid to flexural - gravity waves and bottom - surface waves because their propagation characteristics on the ice surface are of great significance for monitoring the seabed geological structure and water medium. 3. **Reduce the noise signal accumulation time**: In order to improve the efficiency of passive monitoring, the research focuses on how to reduce the noise signal accumulation time required to obtain the seismo - acoustic wave propagation time while expanding the frequency bandwidth for analysis. 4. **Verify the effectiveness of the passive monitoring method**: Through field experiments, the research verifies the effectiveness of the new passive method based on environmental noise analysis in long - distance monitoring of ice sheet parameters. The experimental data show that even in the absence of an active signal source, information about parameters such as ice sheet thickness can be obtained by analyzing environmental noise. In conclusion, the main objective of this paper is to propose an efficient and environmentally - friendly passive seismo - acoustic monitoring method applicable to the Arctic ice - covered area through theoretical analysis and experimental verification, in order to support the long - term monitoring of the geological structure and environmental changes in the Arctic region.