Abstract:Unlike many other surface treatment techniques, such as shot peening (SP), low plasticity burnishing (LPB), ultrasonic surface rolling process (USRP), ultrasonic nanocrystal surface modification (UNSM), laser shock peening (LSP) is a non-contact process. This means that LSP achieves surface modification without direct physical contact, thereby eliminating the risk of media contamination and undesired wear on the peening equipment. As a surface hardening technology, LSP tends to produce a hardened layer with a high gradient of residual stress (RS) in the near-surface, significantly enhancing wear resistance. The well-known wear theories applied for numerical prediction, whether Archard model or dissipated frictional-energy model, contain a multiplier for contact pressure and relative slip amplitude p·ds or shear stress and relative slip amplitude q·ds , respectively. These multipliers are sensitive to the mechanical properties near the surface. Additionally, the wear profile is governed not only by the wear effect but also by the deformation of materials. Therefore, to accurately evaluate the wear performance for surface-hardened materials, the influence of RS is hard to be overlooked. In this work, the finite element method (FEM) is utilised to construct a 3D numerical model, which ignores and considers RS, for both as-received and LSP-treated samples. Two distinct RS distributions induced by different scanning strategies (one- and five-time), are introduced in the finite element (FE) model. The numerical simulation results are then compared with the experimental data to verify the accuracy of the fretting wear model built in this study. On this basis, the impact of different RS distributions on fretting wear characteristics, including wear profile and volume, is extensively investigated. The findings reveal that higher amplitude RS can reduce the degree of fretting wear to a greater extent, highlighting the beneficial role of RS in enhancing wear resistance. Furthermore, the numerical models incorporating RS demonstrate superior predictive accuracy compared to those that omit RS. This naturally underscores the importance of integrating RS in numerical simulations of LSP and other surface-hardened materials.

Influence of surface burnishing process with single strain path and reciprocating strain path on copper wear behavior

Strain effects on the wear rate of severely deformed copper

A Novel Copper Surface Modification Approach Based on Pinless Friction Stir Surface Processing Technique with Ultra-Low Heat Input

Research on the mechanism of the two-dimensional ultrasonic surface burnishing process to enhance the wear resistance for aluminum alloy

Effect of laser shock peening on fretting wear behaviour of AISI 304 stainless alloy

A Gradient Nano/micro-Structured Surface Layer on Copper Induced by Severe Plasticity Roller Burnishing

Enhanced Wear Resistance of 20Cr2Ni4A Steel under Starved Lubrication Conditions via Ultrasonic Surface Burnishing Process

Microstructure and fretting wear behaviour of gradient-structured Cu sheets prepared by plastic flow machining

Effects of Normal Stress, Surface Roughness, and Initial Grain Size on the Microstructure of Copper Subjected to Platen Friction Sliding Deformation

Friction and wear behavior of C implanted copper via ion beam-assisted bombardment

Copper submicrospheres induced by pulsed laser-irradiation with enhanced tribology properties

Influence of Synergistic Effect of Cu Particles and Striated Surface Texture on Tribological Properties

Wear behavior of copper material removal during fluid jet polishing: A comparative study between experiment and simulation

Influence of re-melting rate on the dry sliding wear characteristics of LPBFed Cu–Cr–Zr alloy

Enhancing strength while preserving elongation: A study on copper after accumulative skin pass rolling

Tribological Performance of Multiscale Micro-Textured H62 Brass Surface Fabricated by Micro-Milling and Wet Micro-Blasting

Experimental Study on Pure Copper Subjected to Different Severe Plastic Deformation Modes

Variations in strain affect friction and microstructure evolution in copper under a reciprocating tribological load

Improvement of Wear Resistance in Laser Shock-Peened Copper Contacts

The Effect of Laser Surface Remelting on the Surface Properties of Copper

Enhanced Wear Resistance Of 316 L Stainless Steel With A Nanostructured Surface Layer Prepared By Ultrasonic Surface Rolling