Abstract:The formation of liquid microlayers during the dewetting of a hot surface has significant effects on heat transfer in boiling and evaporation processes. Understanding the criteria for the formation of such microlayers is crucial for explaining the heat transfer characteristics, in particular the heat transfer coefficient (HTC). Research in this area has been almost exclusively concerned with the study of pure liquids, but not with the specific behavior of binary mixtures used in numerous boiling processes. As an example, we investigate the formation of microlayers in ethanol water mixtures, whose global boiling behavior has been widely studied. We conducted dewetting experiments during evaporation with pure ethanol as the reference case and with ethanol/water mixtures with ethanol fractions of 90 % w/w and 70 % w/w. Using high resolution infrared thermography, two evaporation regimes were identified depending on the process conditions and fluid composition: contact line evaporation (CLE) and microlayer evaporation (MLE). The transition from CLE to MLE in pure ethanol was observed at a critical dewetting velocity that depended on wall superheat. Interestingly, for an ethanol water mixture containing 90 wt% ethanol, MLE was observed at all wall superheats and dewetting velocities tested. This can be explained by two specific mixture effects: First, Marangoni convection leads to a flow toward the contact line, and second, the locally increased water concentration near the contact line reduces the evaporating mass flux, which favors film formation and thus MLE. However, with the further increase in water concentration, as with the 70 % ethanol water mixture, MLE was observed only transiently for a few milliseconds, followed by a rapid shift to CLE at all wall superheats and dewetting velocities. These results provide valuable insight into the formation of microlayers in binary mixtures, and thus into the heat transfer characteristics observed in the nucleate boiling studies with binary mixtures.

Theoretical model of microlayer and macrolayer evaporation considering heating surface temperature radial distribution at the bottom of the bubble

Heat Transfer in the Microlayer under a Bubble During Nucleate Boiling

A new microlayer depletion model for numerical simulation of bubble growth during nucleate boiling

Thin Film Evaporation Modeling of the Liquid Microlayer Region in a Dewetting Water Bubble

Predicting initial microlayer thickness in nucleate boiling using Landau–Levich theory

Microlayer in nucleate boiling seen as Landau-Levich film with dewetting and evaporation

Numerical Simulation of Nucleate Pool Boiling under High Pressure Using an Initial Micro-Layer Thickness Model

Numerical Simulation of Single Bubble Growth and Heat Transfer Considering Multi-Parameter Influence During Nucleate Pool Boiling of Water

BUBBLE GROWTH NEAR A WALL DURING NUCLEATE BOILING IN MICROGRAVITY

A BUBBLE-LAYER-BASED MECHANISTIC MODEL FOR THE SLIGHTLY SUBCOOLED FLOW BOILING IN VERTICAL TUBES

On the nature of microlayer formation with ethanol-water mixtures

Direct numerical simulations of microlayer formation during heterogeneous bubble nucleation

Microlayer thickness under a vapor bubble on a cylindrical probe

Mesoscopic Modelling Of Microbubble In Liquid With Finite Density Ratio Of Gas To Liquid

Theoretical modeling of the boiling annular-mist flow in vertical channels

Liquid microlayer thickness along a cylindrical probe

Simulation Of Single Bubble Evaporation In A Microchannel In Zero Gravity With Thermocapillary Effect

Investigation of Bubble Interaction in a Temporal and Spatial Heat Flux Partitioning Model for Subcooled Flow Boiling

Contribution of wall heat transfer in the transition region between microlayer and macroscopic regions to the growth of a single boiling bubble

Modeling of a liquid nitrogen droplet evaporating inside an immiscible liquid pool

A heat transfer model for liquid film boiling on micro-structured surfaces