Abstract:In a vertical latent thermal energy storage (LTES) tank, the lack of natural convection and domination of conduction results in a slow charging rate. On the other hand, due to large thermal resistances between the cold surfaces and liquid phase change material (PCM), the discharge process is also hindered. The current work suggests using multi-tube configurations for LTES tanks to address non-uniform melting and solidification in a vertical LTES unit. These tubes cross each other in the middle of the tank to reach the locations that struggle to melt and solidify. The motivation originates from studies that report a better natural convective heat transfer in titled tubes and that using titled tubes decreases the distance between the locations where PCM struggles to melt/solidify and the heated/cooled surface. A set of numerical simulations is performed to understand the effects of crossing heat transfer tubes on the charging and discharging process by keeping the total volume of the PCM constant. The mentioned numerical simulations utilize the enthalpy-porosity method which are validated using an experimental setup where a singular heat transfer fluid (HTF) tube was present. The study found that increasing the angle between the tubes enhances melting in double-tube configurations. Compared to a conventional LTES unit with one heat transfer fluid (HTF) tube, double-tube cases with 30°, 40°, and 50° angles between the tubes experience faster melting by 16 %, 23 %, and 39 %, respectively. Increasing the number of tubes does not necessarily correspond to faster melting due to hindrance in natural convection when three tubes are used. However, when the number of tubes is increased to four, the melting hastens, and the total melting time decreases up to 47 %. The suggested designs also enhance the solidification performance significantly. Four HTF tubes reduce the solidification time by up to 53 % compared to the conventional one-tube LTES.

Analysis and comparative assessment of charging dynamics in vertical multi-channel latent heat storage system with corrugated wavy channels

Numerical Investigation of Heat Transfer Characteristics in a Shell- And-Tube Latent Heat Thermal Energy Storage System

STUDY ON CHARGING AND DISCHARGING RATES OF LATENT HEAT THERMAL ENERGY STORAGE SYSTEMS EMPLOYING MULTIPLE PHASE CHANGE MATERIALS

Phase change heat transfer and energy storage in a wavy-tube thermal storage unit filled with a nano-enhanced phase change material and metal foams

Comprehensive performance analysis and structural improvement of latent heat thermal energy storage (LHTES) unit using a novel parallel enthalpy-based lattice Boltzmann model

Performance Evaluation and Analysis of a Vertical Heat Pipe Latent Thermal Energy Storage System with Fins-Copper Foam Combination

Thermal performance optimization of novel vertical latent heat storage unit with frustum wavy tube

Performance improvement in a vertical latent thermal energy storage tank with crossing heat transfer tubes

Thermal Charging Optimization of a Wavy-Shaped Nano-Enhanced Thermal Storage Unit

Enhancement of the Thermal Energy Storage Using Heat-Pipe-Assisted Phase Change Material

Performance enhancement of a horizontal latent thermal energy storage unit with elliptical fins

Experimental and numerical investigation of the melting behavior of a phase change material in a horizontal latent heat accumulator with longitudinal and annular fins

Numerical validation and assessment of vertical and horizontal latent heat energy storage system during a melting process

On the performance of a latent heat thermal storage unit integrated with a helically coiled copper tube and organic phase change materials: A lab-scale experimental study

Numerical study on latent heat thermal energy storage with phase change material and metal foam in shell and corrugated tube with external heat losses

Unsteady temperature, heat transfer rate and HTF outlet temperature variation during charging of latent thermal energy storage unit

Comparison of heat transfer between cylindrical and conical vertical shell-and-tube latent heat thermal energy storage systems

A Physics-based Scaling of the Charging Rate in Latent Heat Thermal Energy Storage Devices

Melting Performance Analysis of Phase Change Materials in Different Finned Thermal Energy Storage

Pioneering heat transfer enhancements in latent thermal energy storage: Passive and active strategies unveiled

CFD Analysis of Latent Heat Energy Storage System with Different Geometric Configurations and Flow Conditions