Abstract:Continuous monitoring of physical motion, which can be successfully achieved via a wireless flexible wearable electronic device, is essential for people to ensure the appropriate level of exercise. Currently, most of the flexible LC pressure sensors have low sensitivity because of the high Young’s modulus of the dielectric properties (such as PDMS) and the inflexible polymer films (as the substrate of the sensors), which don’t have excellent stretchability to conform to arbitrarily curved and moving surfaces such as joints. In the LC sensing system, the metal rings, as the traditional readout device, are difficult to meet the needs of the portable readout device for the integrated and planar readout antenna. In order to improve the pressure sensitivity of the sensor, the Ecoflex microcolumn used as the dielectric of the capacitive pressure sensor was prepared by using a metal mold copying method. The Ecoflex elastomer substrates enhanced the levels of conformability, which offered improved capabilities to establish intimate contact with the curved and moving surfaces of the skin. The pressure was applied to the sensor by weights, and the resonance frequency curves of the sensor under different pressures were obtained by the readout device connected to the vector network analyzer. The experimental results show that resonant frequency decreases linearly with the increase of applied pressure in a range of 0–23,760 Pa with a high sensitivity of −2.2 MHz/KPa. We designed a coplanar waveguide-fed monopole antenna used to read the information of the LC sensor, which has the potential to be integrated with RF signal processing circuits as a portable readout device and a higher vertical readout distance (up to 4 cm) than the copper ring. The flexible LC pressure sensor can be attached to the skin conformally and is sensitive to limb bending and facial muscle movements. Therefore, it has the potential to be integrated as a body sensor network that can be used to monitor physical motion.

Low-Profile Radio Frequency Pressure Sensor Based on Additive Manufacturing Technology

Flexible capacitive pressure sensor array using acoustic-assisted fabrication of microstructures as surface and dielectric layers

Flexible Pressure Sensor with Micro-Structure Arrays Based on PDMS and PEDOT:PSS/PUD&CNTs Composite Film with 3D Printing

3D-Printed Graphene Nanoplatelets/Polymer Foams for Low/Medium-Pressure Sensors

A Wearable Pressure Sensor Based on the Array of Polymeric Piezoelectric Fiber with Metal Core.

A Flexible Wireless Pressure Sensor Based on UHF RFID Technology

Additively Manufactured Stress-strain Dependant Frequency Reconfigurable Antenna for Pressure Sensor Applications

Flexible Copper Nanowire Electronics for Wireless Dynamic Pressure Sensing

Radio Frequency Resonator-Based Flexible Wireless Pressure Sensor with MWCNT-PDMS Bilayer Microstructure

Flexible Wireless Passive LC Pressure Sensor with Design Methodology and Cost-Effective Preparation

A Novel Resistive Sensor Network Utilizing an SAP-Enhanced Ionic Layer and CNT Doping for Multipoint Pressure Measurement

Printing conformal and flexible copper networks for multimodal pressure and flow sensing

3D Printing of a Flexible Inclined‐Tip Cone Array‐Based Pressure Sensor

High-Performance Flexible Piezoresistive Pressure Sensor Printed with 3D Microstructures

Low-Cost and Highly Sensitive Pressure Sensor with Mold-Printed Multi-Walled Carbon Nanotubes Dispersed in Polydimethylsiloxane

Wireless mm-Wave Chipless Pressure Sensor

Flexible and Highly Sensitive Pressure Sensors Based on Microstructured Carbon Nanowalls Electrodes

Anisotropic piezoresistive response of 3D-printed pressure sensor based on ABS/MWCNT nanocomposite

High‐Performance Flexible Pressure Sensor Based on Controllable Hierarchical Microstructures by Laser Scribing for Wearable Electronics

Preparation and Performance of Wearable Pressure Sensor Based on Three-Dimensional Flexible Fabric and Its Wireless Transmission System

Ultralow-Cost, Highly Sensitive, and Flexible Pressure Sensors Based on Carbon Black and Airlaid Paper for Wearable Electronics