Abstract:As the world's first time implementation of MR-based smart damping technique in bridge structures, a total of 312 semi-active magneto-rheological (MR) dampers have recently been installed on the cable-stayed Dongting Lake Bridge for wind-rain-induced cable vibration control. Prior to the full implementation, a comprehensive field vibration test, has been conducted on the longest cable of 150 in to identify and compare damping performance of the cable-damper system under different damper installation setups and under a wide spectrum of voltage inputs to the MR dampers. Forced vibration experiments were carried out for the cable without damper, with single-damper setup, and with twin-damper setup, respectively. One purpose of this in-situ experimental investigation is to determine the optimal input voltage which achieves maximum system damping for the aim of designing a multi-switch control strategy. Due to geometric nonlinearity of cables and hysteretic nonlinearity of MR dampers, the equivalent modal properties of the cable-damper system are deemed to be amplitude-dependent. Keeping this in mind, a Hilbert transform based method is deployed in the present study to identify the amplitude-dependent natural frequencies and modal damping from the sinusoidal-decay response data. The experimental and identification results show that the equivalent modal damping ratios of the system are noticeably dependent on vibration amplitude and the relevance of the natural frequencies to vibration amplitude is negligible. The single-damper setup is competitive with the twin-damper setup in suppressing in-plane vibration of the cables. However, when mitigation of cable out-of-plane vibration is also required, the twin-damper setup performs much better. For both setups, the value of optimal voltage is found to be mode-dependent and amplitude-dependent.

Spacers combined with dampers for the wake-induced vibration mitigation of two parallel hanger cables

CHARACTERISTICS OF MODAL DAMPING OF STEEL AND CFRP STAY CABLES WITH OIL DAMPERS

INVESTIGATION OF DAMPING MATRICES ACCURATE ESTIMATION OF CABLE-STAYED BRIDGES BASED ON NON-PROPORTIONAL DAMPING

Damping characteristics of PC partial cable-stayed bridge

Wake-induced vibration of a suspender cable in the rear of a bridge tower

Multi-Mode Vibration Control of Super-Long Stay Cables with Negative Stiffness and Stockbridge Dampers

SIMULATION ANALYSIS FOR VIBRATION MITIGATION OF STAY-CABLE BY MR DAMPERS UNDER SEMI-ACTIVE CONTROL STRATEGY

Damping and tuning of inerter-based dampers for cable vibration mitigation considering girder vibrations

Optimal design of transverse dampers incorporating inherent stiffness effects for stay cable vibration control: A case study with wire rope dampers

Numerical Simulation of Vibration Control for Stay Cable Using MR Dampers

Vibration Damping of a Taut Cable with the Hybrid Application of a Viscous Damper and a Tuned Mass Damper

EXPERIMENTAL STUDY ON VIBRATION MITIGATION OF A STAY CABLE USING NONLINEAR HYSTERETIC DAMPERS

Inertial Mass Damper for Mitigating Cable Vibration

Free vibration of a taut cable with internal high damping rubber dampers and an external negative stiffness damper

Maximum modal damping of cable space vibration control with viscous damper in cable-stayed bridge

Design Formulas for Vibration Control of Taut Cables Using Passive MR Dampers

Amplitude-dependent Frequency and Damping Identification of Bridge Cables with MR Dampers in Different Setups

Dynamic Behaviors of a Two‐Cable Network With Two Negative Stiffness Dampers and a Cross‐Tie

Design optimization of Magneto-rheological (MR) dampers for open-loop vibration control of stay cables

MR Dampers-Based Semi-Active Control Strategy of Cable-Stayed Vibration

Wind-Induced Vibration Control of High-Rise Structures Using Compound Damping Cables