Abstract:The centrifugal compressor is widely used for gas compression in various industrial fields such as aero-engine, gas turbine and turbocharger. However, the stable operating range is usually restricted by the occurrence of flow instability such as stall and surge. The paper experimentally examines the developing process of surge and stall occurring in a centrifugal compressor to advance the understanding on flow mechanism of flow instability. It is found that three types of pressure fluctuation can be observed at low flowrate region. At the critical point, the local stall firstly occurs in some specific diffuser passages and the enlarged local diffuser stall eventually induces the mild surge of compression system indicated by the sinusoidal pressure fluctuation. At lower mass flow rate, the diffuser stall cell begins to circumferentially propagate along the impeller rotating direction at 11% of rotor speed with the existence of mild surge. In comparative analysis of IGV pre-swirl angle on the occurrence of mild surge, the mild surge still occurs at the operating condition when the slope of the characteristic map of test stage is still obviously negative, in which the compression system is supposed to be stable in previous study. And a new suggested criterion for the prediction of mild surge is demonstrated that the occurrence of mild surge depends on the destabi-lization effect of downstream components about diffuser and volute. Combined with the experimental data, the streamwise distribution characteristic of diffuser stall can be used to develop the simplified model of lumped parameters for the analysis on the generation mechanism of the diffuser rotating stall. The quantitative investigation on the relation between the pressure-rise characteristic of subcomponents and the occurrence of mild surge and diffuser rotating stall not only advances the prediction of stability limit but also lays the theoretic foundation for controlling these unsteady behaviors to improve the operating range.

Centrifugal compressor surge and speed control

Surge Process of a High-Speed Axial–Centrifugal Compressor

Experimental investigation of transient characteristics of mild surge and diffuser rotating stall in a centrifugal compressor with vaned diffuser

Compressor Stability at Pulsating Condition Via Gas Dynamics Responses Analysis

Active Surge Control for Variable Speed Axial Compressors.

Experimental Investigation of Surge and Stall in a High-Speed Centrifugal Compressor

Fuzzy logic surge control in variable speed axial compressors

Two-Regime Surge Mechanism in Centrifugal Compressors

Stall Margin Improvement in an Axial Compressor by Continuous and Pulsed Tip Injection

Generation Mechanisms of Rotating Stall and Surge in Centrifugal Compressors

Flow Physics During Surge of an Axial-Centrifugal Compressor

Numerical Investigation of Flow Evolution in Centrifugal Compressors During Surge

Numerical Model of a Deep Surge Cycle in Low-Speed Centrifugal Compressor

INVESTIGATION ON THE UNSTEADY SURGE FLOW BEHAVIOR OF AN AXIAL-CENTRIFUGAL COMPRESSOR

Backward Traveling Rotating Stall Waves in Centrifugal Compressors

Aerodynamic Instability Evolution of a Multi-Stage Combined Compressor

Flow Instability Evolution in High Pressure Ratio Centrifugal Compressor with Vaned Diffuser

Phenomenon and Mechanism of Two-Regime-Surge in a Centrifugal Compressor

Investigation of the Mild Surge in an Axial–centrifugal Compressor

Improvement in the Stability of A Turbocharger Centrifugal Compressor by Tip Leakage Control

The Role of Shaft-Speed Oscillation on the Instability Behavior of Transonic Radial Compressor