Abstract:This research is focused on the experimental measurement of the thermal conductivity of CF 3 I and the subsequent development of empirical models, which are integral to engineering system design calculations. CF 3 I is identified as a potential key component in the formulation of future refrigerant mixtures, owing to its non-explosive nature, low toxicity, and minimal contribution to ozone layer depletion and global warming. Its applicability is further reinforced by its advantageous thermodynamic properties, including a low boiling point and a high critical temperature, making it a vital constituent in refrigerant mixtures. The study employs the well-established transient hot-wire method to measure the thermal conductivity of CF 3 I in both its liquid and vapor phases. This method is characterized by the sequential arrangement of two platinum wires which are linked in parallel to nullify any impacts from axial heat conduction. Experimental data were methodically gathered across a range of temperatures, spanning from 311 K to 374 K for the liquid phase and from 312 K to 394 K for the vapor phase, under varying pressures from 1.5 MPa to 4.0 MPa and 0.5 MPa to 3.0 MPa, respectively. The combined uncertainties associated with these measurements were meticulously calculated, amounting to 1.8% for the liquid phase and 2.0% for the vapor phase. Furthermore, the research advanced to the development of thermal conductivity models for CF 3 I, employing both the Extended Corresponding States method and the modified Residual Entropy Scaling method. These models effectively encapsulate the empirical findings, fitting within the established uncertainty limits with reasonable extrapolating behavior. Critically, these models are expected to play a pivotal role in predicting the thermal conductivity of refrigerant mixtures that incorporate CF 3 I as a component, marking a significant contribution to the field of refrigerant technology.

Correlations for the Viscosity and Thermal Conductivity of Tetrahydrofuran

New Correlation Model of Thermal Conductivity of Liquid Hydrofluorochloro Derivatives of Olefins, Hydrofluorocarbons, and Hydrochlorofluorocarbons

Improved Correlation for Viscosity from Surface Tension Data for Saturated Normal Fluids

Reference Correlation of the Viscosity of Ethene from the Triple Point to 450 K and up to 195 MPa

Reference Correlations for the Density and Thermal Conductivity, and Review of the Viscosity Measurements, of Liquid Titanium, Zirconium, Hafnium, Vanadium, Niobium, Tantalum, Chromium, Molybdenum, and Tungsten

A new correlation for thermal conductivity of liquids

Viscosity Correlations of Normal Gases at Normal Pressures and Several HFC Refrigerants Using the Corresponding States Theory

A New Heat Transfer Correlation for Supercritical Fluids

New Correlation for the Thermal Conductivity of Gaseous Fluorocarbon Refrigerants

Modeling the Viscosity of Hydrofluorocarbons, Hydrofluoroolefins and Their Binary Mixtures Using Residual Entropy Scaling and Cubic-Plus-association Equation of State

Correlation for Third Virial Coefficients of Pure Fluids

Viscosity Correlation of CO2, HFCs, HFOs, and Their Mixtures: Review of Experimental Data and Modeling Techniques

Correlations for second and third virial coefficients of pure fluids

A General Correlation for Saturated Two-Phase Flow Boiling Heat Transfer Inside Horizontal and Vertical Tubes

Heat Transfer Correlations for Single-Phase Flow, Condensation, and Boiling in Microfin Tubes

Correlation for Viscosities of Pure Liquids at High Pressures

Reference Correlation of the Viscosity of N-Hexadecane from the Triple Point to 673 K and Up to 425 MPa

Reference Correlations for the Thermal Conductivity of Solid BK7, PMMA, Pyrex 7740, Pyroceram 9606 and SS304

Reference Correlation of the Viscosity of Ortho-Xylene from 273 to 673 K and Up to 110 Mpa

Measurement and Empirical Models of Thermal Conductivity of Trifluoroiodomethane (CF3I)

Prediction of the Thermal Conductivity of H2/CO2/CO/CH4/H2O Mixtures at High Temperatures and High Pressures Based on the Extended Corresponding States Principle