Abstract:There is interest in exporting carbon-neutral liquid hydrogen (LH2) as a replacement for fossil fuels. However, transporting LH2 for maritime export is made difficult by the requirement for high performance insulation to reduce pressure rise and cargo losses through venting. One method to reduce boil-off losses is to allow the tank to self-pressurise along the journey and delay venting by increasing the tank maximum allowable working pressure (MAWP). To assess this, an analytical model was developed, in Matlab, to predict pressure rise and boil-off gas (BOG) generation. Perlite insulation was modelled using analytical expressions for temperature-dependent specific heat capacity and thermal conductivity. The model was tuned over a range of data, including for pressure and boil-off rate. This model was used to assess an LH2 carrier carrying four 40,000 m3 spherical tanks insulated with evacuated perlite. At atmospheric pressure, a loss rate of 0.04 % per day was predicted for the laden voyage. Over a voyage duration of 15 days the model predicts that boil-off can be reduced by 31 % when the tank is allowed to self-pressurise to 5 kPaG. This is primarily due to a reduced rate of boil-off as the liquid transitions from a subcooled to a saturated state. At higher pressures, the delay in venting was observed to be a major contributor to reduction in boil-off, with a reduction of 91 % in losses at MAWP of 60 kPaG. Pressure rise was observed to be significantly greater than a saturated liquid model would suggest, particularly at high fill levels. Finally, an empirical equation for the pressure rise was fitted to 27 data points from the literature, allowing for quick estimates of the pressure rise based on the fill level, the Rayleigh number and the surface to volume ratio in the ullage. This study suggests very low loss storage of LH2 can be achieved in large double-wall tanks over a sufficiently short journey, with only marginal pressurisation. Additional investigations on the effect of ship motion on phase change within the tank will be required to fully understand design considerations for LH2 storage tanks.

Characterization and monitoring of vacuum pressure of tank containers with multilayer insulation for cryogenic clean fuels storage and transportation

Prediction of Dormancy Time of Cryo-Compressed Hydrogen Tank by Considering Dynamic Thermal Boundary

Thermodynamic analysis and comparison of four insulation schemes for liquid hydrogen storage tank

Perspective for the Safe and High-Efficiency Storage of Liquid Hydrogen: Thermal Behaviors and Insulation

Modeling and thermodynamic analysis of thermal performance in self-pressurized liquid hydrogen tanks

Research progress of lossless and safe storage technology for cryogenic liquid tanks

Numerical Study on Composite Multilayer Insulation Material for Liquid Hydrogen Storage

Theoretical investigation on heat leakage distribution between vapor and liquid in liquid hydrogen tanks

Theoretical Analysis of Entropy Generation in Multilayer Insulations: A Case Study of Performance Optimization of Variable Density Multilayer Insulations for Liquid Hydrogen Storage Systems

Experimental study of the influences of degraded vacuum on multilayer insulation blankets

Investigation on Performances of Non-Loss Storage for Cryogenic Liquefied Gas

Theoretical and Experimental Study for Static Evaporation Rate of a Self-Developed Liquid Hydrogen Storage Tank

Experimental investigation on the discharge and suction gas performance in the multilayer insulation microchannels

Dynamic Thermal Performance of Cryogenic Liquid Hydrogen Heating from Gas-Liquid Stratification to Supercritical under a Constant Heat Flux Condition: A Two-Step Simulation

A Novel Composite Insulation System of Hollow Glass Microspheres and Multilayer Insulation with Self‐Evaporating Vapor Cooled Shield for Liquid Hydrogen Storage

Transient-state Modeling and Thermodynamic Analysis of Self-Pressurization Liquid Hydrogen Tank Considering Effect of Vacuum Multi-Layer Insulation Coupled with Vapor-Cooled Shield

Thermodynamic modelling of pressurised storage and transportation of liquid hydrogen for maritime export

Modeling and pressure control characteristics of thermodynamic venting system in liquid hydrogen storage tank

Experimental study on pressure and evaporation rate of cryogenic liquid boil-off gas re-liquefaction system

Comprehensive Design and Preliminary Experiments of Liquid Hydrogen Storage Tank for Trucks

Design of Thermal Insulation for Lng Tanker