Abstract:Solar energy is clean and abundant, and it has been considered as a green energy. Solar energy can be utilized by photovoltaics (PV) or concentrating solar power (CSP) generation. PV converts solar energy into electricity cost-effectively, but it is sensitive to environmental conditions, such as weather, and unable to utilize spectrum outside the spectral response range. In contrast, CSP is less sensitive to environment conditions, but more costly than PV. Their advantages can be combined by integrating PV and CSP into a beam-splitting photovoltaic-thermal (PV-T) hybrid system, which splits incident solar radiation and projects the photovoltaic spectrum onto solar cells and the rest to CSP. In this way, full spectrum of solar radiation can be utilized, and the overall conversion efficiency is enhanced by increasing the efficiency of solar cells and heat. The beam-splitting PV-T system has shown a great potential in solar energy production; however, few studies consider hybrid systems with the newly emerging perovskite solar cells. This paper reports a perovskite solar cell (PSC) with various bandgaps by replacing Iodine ion (I−) in FA1-xMAxPbI3 with Bromine ion (Br−) in different proportions. In addition, the spectral response ranges of PSC were adjusted to 300–700, 300–730, 300–780, 300–800 and 300–830 nm in external quantum efficiency (EQE) curves. We also analyzed the trends of photovoltaic properties of PSC, measured with solar simulator, validated with characterization of perovskite films. Furthermore, a beam-splitting PV-T system with PSC of different spectral response ranges was simulated and optimized using the experimental data. Results show that the beam-splitting PV-T system can achieve a theoretical solar-to-electric efficiency of 25.74%. This efficiency is higher than those of single CSP and single PSC, which are 23.97% and 17.27% respectively. The efficiency tends to decline with ratio of Br− increasing, because though the open-circuit voltage boosts and EQE remains unchanged, the declined quality of PSC reduces the fill factor, which is detrimental to the overall efficiency. Even though introducing Br− cannot increase the overall efficiency, the changed spectral response range brings about shift of the optimum cutoff wavelength, and the efficiency just slightly decreases with low ratio of Br− mixing, which is important for matching beam splitters in beam-splitting PV-T system.

Enhancing photovoltaic performance through solar radiation splitting: A beam splitter-assisted hybrid approach with 2-D tracking and PCM integration

Performance Analysis of a Novel Combined Cooling, Heating and Power System with Solar Energy Spectral Beam Splitting

Using perovskite solar cells with tunable bandgaps for beam-splitting photovoltaic-thermal System

Effects of beam splitting on photovoltaic properties of monocrystalline silicon, multicrystalline silicon, GaAs, and perovskite solar cells for hybrid utilization

Thermodynamic and Optical Analysis for A Cpv/T Hybrid System with Beam Splitter and Fully Tracked Linear Fresnel Reflector Concentrator Utilizing Sloped Panels

Design and thermodynamic analysis of a novel solar CPV and thermal combined system utilizing spectral beam splitter

Optical Analysis of a Hybrid Solar Concentrating Photovoltaic/Thermal (CPV/T) System with Beam Splitting Technique

Thermodynamic and Optical Analyses of a Hybrid Solar CPV/T System with High Solar Concentrating Uniformity Based on Spectral Beam Splitting Technology

Experimental Investigation on Energy Performance of hybrid PV/T-PCM system

A Hybrid Parabolic Trough Solar Collector System Integrated with Photovoltaics

Perovskite Solar Cells with Tunable Bandgaps for Beam-Spiltting Photovoltaic-Thermal System

Design and Analysis of Two-Stage Transmitted-Reflected Concentration Pv/Thermal System with Spectral Beam Splitter

Boosting Total Conversion Efficiency of Hybrid Photovoltaic–Thermal Via a Spectral Splitter/Absorber Based on Lossy Periodic Structured Media

Spectral Splitting As a Route to Promote Total Efficiency of Hybrid Photovoltaic Thermal with a Halide Perovskite Cell

Advancing performance assessment of a spectral beam splitting hybrid PV/T system with water-based SiO2 nanofluid

Investigation on Thermal and Electrical Performance of Late-Model Plate-and-Tube in Water-Based PVT-PCM Collectors

Progress in Full Spectrum Solar Energy Utilization by Spectral Beam Splitting Hybrid PV/T System

Performance study of photovoltaic-thermochemical hybrid system with Cassegrain concentrator and spectral splitting integration

A dish-type high-concentration photovoltaic system with spectral beam-splitting for crop growth

MODEL DEVELOPMENT AND PERFORMANCE IMPROVEMENT OF A PHOTOVOLTAIC-THERMOELECTRIC SYSTEM BY INTEGRATING AND OPTIMIZING PHASE CHANGE MATERIALS

Efficiency enhancement of photovoltaic module using bio-based eutectic phase change material: An experimental study