Abstract:The microstructure evolution of Ni-based superalloys during heat treatment is of great significance for obtaining better service performance. However, heat treatment experimentation is costly and time-consuming, and sometimes fails to reveal physical mechanisms well. In the present study, a multiphase-field model coupled with an explicit nucleation algorithm was established to simulate the precipitation and growth of γ′ phase in DD6 superalloy, which can be applied to a multicomponent elastic-inhomogeneous system. The PanNickel© database was used to calculate thermodynamic and kinetic data in multicomponent superalloys. First, the coupling method of multiphase-field model and explicit nucleation algorithm was introduced. The coupled model was used to simulate the precipitation of γ′ phase under isothermal and non-isothermal conditions. It was found that a unimodal microstructure was formed under isothermal conditions and there was a “soft impingement” phenomenon, while a bimodal distribution composed of cuboidal γ′ precipitates and fine secondary γ′ precipitates was formed during a cooling process of 25–125 °C/min. The effect of cooling rate was studied. Then, the chemical and elastic driving forces were analyzed. It was found that Al and Ta contributed most to the chemical driving force, while Re and W gathered at the γ/γ′ interface and inhibited the growth of γ′ phase. γ′ precipitates had a cuboidal shape under the influence of elastic driving force. Finally, the growth and coarsening process of γ′ phase was studied and compared with the well-known Lifshitz−Slyosov−Wagner (LSW) theory. The growth of γ′ phase can be divided into rapid growth, coarsening and quasi-static coarsening stages according to the simulation results, among which the coarsening stage is basically consistent with the LSW theory. The current model can be used to simulate the precipitation and growth of single crystal superalloys where multicomponent and elastic effects are considered.

First-principles study for quasi-static growth model in FeAl intermetallic based on Wulff cluster model

Phase-field Model Simulations of Alloy Directional Solidification and Seaweed-Like Microstructure Evolution Based on Adaptive Finite Element Method

Phase-Field Model of Isothermal Solidification with Multiple Grain Growth

Early Stages of Precipitation in Γ' Phase of a Ni–Al–Ti Model Alloy: Phase-Field and First-Principles Study

Multi-component Phase-Field Simulation of Microstructural Evolution and Elemental Distribution in Fe–Cu–Mn–Ni–Al Alloy

Phase-field model of isothermal solidification in multicomponent alloys for multiple grains

Simulation of Multiple Grains for Isothermal Solidification of Binary Alloy Using Phase-Field Model

The Microstructure in an Al–Ti Alloy Melt: The Wulff Cluster Model from a Partial Structure Factor

Theoretical and experimental study of the microstructure of a metallic melt in an In 50 Bi 50 alloy based on the Wulff cluster model

The structure of metallic melts in eutectic alloys based on the Wulff cluster model: theory meets experiment

Ab Initio Investigation Of Phosphorus And Hydrogen Co-segregation And Embrittlement In α-fe Twin Boundaries

Simulation for microstructure evolution of Al-Si alloys in solidification process

First principles study on the mechanism of abnormal viscosity change of pure Al & Pb melts based on Wulff cluster model

A new scheme for simulating diffusion-controlled growth in multi-component alloys

Stability of FeAl(110) Alloy Surface Structures: a First-Principles Study

Systematic study of growth behavior of β-Al9Fe2Si2 in Al alloys with high iron and silicon contents

Precipitation and Growth Simulation of Γ′ Phase in Single Crystal Superalloy DD6 with Multiphase-Field Method and Explicit Nucleation Algorithm

First principles study on heterogeneous interfaces of TiCu alloys through aluminum addition

Numerical modeling of equiaxed crystal growth in solidification of binary alloys using a lattice Boltzmann-finite volume scheme

First-principles Calculations of Bulk and Interfacial Thermodynamic Properties of the T1 phase in Al-Cu-Li alloys

Phase-field modeling of microstructure evolution of Cu-rich phase in Fe–Cu–Mn–Ni–Al quinary system coupled with thermodynamic databases