Abstract:The proton-exchange membrane fuel cell (PEMFC) bipolar plate serpentine flow channel U-shaped region is prone to the accumulation effect, which poses serious difficulties for fuel cell water management. As a result, a deep understanding of water transport in the U-shaped region is essential to improve the fuel cell performance. Under this direction, in this work, the impact of the different microstructure parameters and initial conditions on water transport in the U-shaped region was compared with and without microstructure using the volume of the fluid method. On top of that, the velocity field distribution in the X-direction and the pressure drop distribution in the flow channel were also analyzed. From the acquired results, it was demonstrated that due to the secondary flow caused by the bending property of the microstructure, the droplet movement time in the U-shaped region was significantly shortened after the microstructure was added in the U-shaped region. The initial conditions strongly affected the droplet motion, and a larger contact angle enhanced the wall hydrophobicity to facilitate the droplet discharge. An increase in the droplet diameter led also to a rise in the windward area and shear force, which shortened droplet discharge time. Interestingly, if the waveform microstructure has too-large crests, gullies will be created that will impede the droplet motion and increase the amplitude of the droplet oscillation, resulting in excessive pressure drop in the flow channel. A too-large period led to increased droplet momentum loss, whereas a short period reduced the wall contact angle, which is not conducive to drainage. The microstructure spacing significantly affected the droplet motion, and the reduced spacing increased the airflow diffusion effect to accelerate the flow rate. The main focus of this work was led on the application of the microstructure in a U-shaped region of the serpentine flow channel, which is of great specific significance for droplet removal inside the flow channel.

Liquid water discharge capability enhancement of hierarchical pore structure in metal foam flow field of proton exchange membrane fuel cell

Water management and performance enhancement in proton exchange membrane fuel cell through metal foam flow field with hierarchical pore structure

Investigation of metal foam porosity and wettability on fuel cell water management by Electrochemical Impedance Spectroscopy

Effects of gradient porosity in the metal foam flow field on the performance of a proton exchange membrane fuel cell

Experimental performance investigation on the arrangement of metal foam as flow distributors in proton exchange membrane fuel cell

Water management and structure optimization study of nickel metal foam as flow distributors in proton exchange membrane fuel cell

Thermal management improvement of air-cooled proton exchange membrane fuel cell by using metal foam flow field

Numerical Studies of Interfacial Phenomena in Liquid Water Transport in Polymer Electrolyte Membrane Fuel Cells Using the Lattice Boltzmann Method

Developing Next Generation High Performance Polymer Electrolyte Membrane Fuel Cells Using Metal Foam As Gas Diffusion Layer

Three-Dimensional Lattice Boltzmann Simulation of Liquid Water Transport in Porous Layer of PEMFC.

Numerical investigation on the feasibility of metal foam as flow field in alkaline anion exchange membrane fuel cell

Effects of Microstructure on Water Removal in the U-Shaped Region of PEMFC Serpentine Flow Channel

Design and Modelling of 3D Bionic Cathode Flow Field for Proton Exchange Membrane Fuel Cell

Metal-foam-based cathode flow-field design to improve H2O retention capability of passive air cooled polymer electrolyte fuel cells

Investigation on performance of full-scale proton exchange membrane fuel cell: Porous foam flow field with integrated bipolar plate/gas diffusion layer

Structured mesh material with gradient surface wettability for high-power-density proton exchange membrane fuel cells

Performance enhancement in a proton exchange membrane fuel cell with a novel 3D flow field

Water transport in PEMFC with metal foam flow fields: Visualization based on AI image recognition

Porous Flow Field for Next-Generation Proton Exchange Membrane Fuel Cells: Materials, Characterization, Design, and Challenges

Enhanced Water Removal Performance of a Slope Turn in the Serpentine Flow Channel for Proton Exchange Membrane Fuel Cells

Metal foam flow fields in polymer electrolyte membrane fuel cells: Performance and durability under severe operating conditions