Abstract:Structural aerospace composite parts are commonly cured through autoclave processing. To optimize the autoclave process, manufacturing process simulations have been increasingly used to investigate the thermal behavior of the cure assembly. Performing such a simulation, computational fluid dynamics (CFD) coupled with finite element method (FEM) model can be used to deal with the conjugate heat transfer problem between the airflow and solid regions inside the autoclave. A transient CFD simulation requires intensive computing resources. To avoid a long computing time, a quasi-transient coupling approach is adopted to allow a significant acceleration of the simulation process. This approach has been validated for a simple geometry in a previous study. This paper provides an experimental and numerical study on heat transfer in a medium-sized autoclave for a more complicated loading condition and a composite structure, a curved shell with three stringers, that mocks the fuselage structure of an aircraft. Two lumped mass calorimeters are used for the measurement of the heat transfer coefficients (HTCs) during the predefined curing cycle. Owing to some uncertainty in the inlet flow velocity, a correction parameter and calibration method are proposed to reduce the numerical error. The simulation results are compared to the experimental results, which consist of thermal measurements and temperature distributions of the composite shell, to validate the simulation model. This study shows the capability and potential of the quasi-transient coupling approach for the modeling of heat transfer in autoclave processing with reduced computational cost and high correlation between the experimental and numerical results.

Research on Air-Flow-Field Characteristics and Structural Optimization of the Guide Channels of the Autoclave

Optimizing Flow Field in an SCR System of a 600 MW Power Plant: Effects of Static Mixer Alignment Style

Non-linear mapping and multi-objective optimization of leading flow structure in plate-fin heat exchanger

Influence of Large Framed Mold Placement in Autoclave on Heating Performance

Prediction of the Temperature of Large Framed Mold and Curing Deformation of Composite Components in the Autoclave Process

Computational Fluid Dynamics Simulations and Experimental Validation of Macromixing and Flow Characteristics in Low-Density Polyethylene Autoclave Reactors

A Heat-Balance Method for Autoclave Process of Composite Manufacturing

Controlling Law of Flow and Mixing Behavior in an Autoclave for the Production of Low-Density Polyethylene

Design Optimization of Molds for Autoclave Process of Composite Manufacturing

Numerical investigation of the effect of thermal gradients on curing performance of autoclaved laminates

Study and optimization on characteristics of temperature field in forced convection oven

Effect of Inlet Flow Maldistribution on the Passage Arrangement Design of Multi-Stream Plate-Fin Heat Exchanger

Numerical simulation and parameter analysis of temperature distribu-tion of autoclave cured composite cylindrical structure

Simulation of Multi-Phase Flow in Autoclaves Using a Coupled CFD-DPM Approach

Enhancing heat transfer efficiency in corrugated tube heat exchangers: A comprehensive approach through structural optimization and field synergy analysis

Flow Analysis and Optimization of the Air channel of Drying Chamber Based on CFD

Numerical Simulation of Gas-Liquid Two-Phase Flow in Agitator Tank of Autoclave

Experimental validation of a quasi-transient coupling approach for the modeling of heat transfer in autoclave processing

Research on optimization of structural parameters for airfoil fin PCHE based on machine learning

Optimization of air flow field for direct air cooling units

Heat transfer simulation and improvement of autoclave loading in composites manufacturing