Abstract:In string musical instruments, the sound is radiated by the soundboard, subject to the strings excitation. This vibration of this rather complex structure is described here with models which need only a small number of parameters. Predictions of the models are compared with results of experiments that have been presented in Ege et al. [Vibroacoustics of the piano soundboard: (Non)linearity and modal properties in the low- and mid- frequency ranges, Journal of Sound and Vibration 332 (5) (2013) 1288-1305]. The apparent modal density of the soundboard of an upright piano in playing condition, as seen from various points of the structure, exhibits two well-separated regimes, below and above a frequency flim that is determined by the wood characteristics and by the distance between ribs. Above flim, most modes appear to be localised, presumably due to the irregularity of the spacing and height of the ribs. The low-frequency regime is predicted by a model which consists of coupled sub-structures: the two ribbed areas split by the main bridge and, in most cases, one or two so-called cut-off corners. In order to assess the dynamical properties of each of the subplates (considered here as homogeneous plates), we propose a derivation of the (low-frequency) modal density of an orthotropic homogeneous plate which accounts for the boundary conditions on an arbitrary geometry. Above flim, the soundboard, as seen from a given excitation point, is modelled as a set of three structural wave-guides, namely the three inter-rib spacings surrounding the excitation point. Based on these low- and high-frequency models, computations of the point-mobility and of the apparent modal densities seen at several excitation points match published measurements. The dispersion curve of the wave-guide model displays an acoustical radiation scheme which differs significantly from that of a thin homogeneous plate. It appears that piano dimensioning is such that the subsonic regime of acoustical radiation extends over a much wider frequency range than it would be for a homogeneous plate with the same low-frequency vibration. One problem in piano manufacturing is examined in relationship with the possible radiation schemes induced by the models.

Absorption Cross Section of a Pipe Organ Due to Resonant Vibration of the Pipe Walls

Tone generation in an open-end organ pipe: How a resonating sphere of air stops the pipe

An Acoustic Black Hole Absorber for Rail Vibration Suppression: Simulation and Full-Scale Experiment

On the Dynamics of the Flow and the Sound Field of an Organ Pipes's Mouth Region

On the Design of Sound Absorbing Ducts

Vibroacoustics of the piano soundboard: Reduced models, mobility synthesis, and acoustical radiation regime

Sounding Mechanism of a Flue Organ Pipe—A Multi-Sensor Measurement Approach

Synchronization of organ pipes: experimental observations and modeling

Vibrational and acoustical characteristics of the piano soundboard

Analysis of Sound Absorption Characteristics of Acoustic Ducts with Periodic Additional Multi-Local Resonant Cavities

Acoustic Resonance in an Annular Cavity with Axial Transit Flow

Acoustic performance of fabric pipe in intake system

Acoustic absorption and generation in ducts of smoothly varying area sustaining a mean flow and a mean temperature gradient

Sound-Absorption Mechanism of Structures with Periodic Cavities

Sound Propagation in Ducts Lined with Absorbing Materials

Inverse Doppler Effects in Pipe Instruments

Optimal shaping of acoustic black holes for sound absorption in air

Investigation of the effects of pipe diameter of internal multiphase flow on pipe elbow vibration and resonance

Study of Acoustic Vibration in Piping Systems by Energy-Based Finite Element Analysis

Numerical study on role of foot of a flue organ pipe: relative phases in oscillations among pipe, foot and jet

Rectangular extended neck Helmholtz resonant acoustic structure for low frequency broadband sound absorption