Nano ferric oxide adsorbents with self-acidification effect for efficient adsorption of Sb(V)

Xiuping Feng,Ruixin Yan,Qinggang Zhang,Qun Wan,Takeshi Hagio,Ryoichi Ichino,Long Kong,Xinde Cao,Liang Li

DOI: https://doi.org/10.1016/j.chemosphere.2021.129933

IF: 8.8

2021-06-01

Chemosphere

Abstract:It is urgent and essential to remove antimony from wastewater due to its potential carcinogenicity. In this paper, a nano ferric oxide (NFO) adsorbent was synthesized in a one-step low temperature calcination (150 °C) process. It presents a surprising self-acidification behavior, could automatically adjust the pH to around 4 from different intimal pH values (4-9), which enable it to efficiently remove more than 99% of Sb(V) from wastewater in a wide pH range. X-ray photoelectron spectroscopy analysis proved that the self-acidification function was originated from the hydrolyzation of surface Fe atoms on ferric oxide nanoparticles. The maximum adsorption capacity of this adsorbent is 78.1 mg/g which is 2-3 times higher than that of the samples obtained at higher temperatures (250 °C and 350 °C), and also its adsorption kinetic constant is ten times higher, which can be attributed to the larger surface areas and smaller sizes of ferric oxides synthesized at 150 °C. In the actual wastewater treatment, the effluent's concentration after treatment can be maintained below the instrument detection limit even under low initial antimony concentration. We believe that this new adsorbent has great potential in the practical application in the treatment of Sb polluted wastewaters due to its simple synthesis, high efficiency, and low cost.

environmental sciences