Abstract:Innovations in lithium-ion batteries rely crucially on the availability of advanced characterization techniques. High-resolution chemical imaging of low-Z elements e.g., lithium (Li) is often difficult in many conventional chemical analysis techniques such as Energy-Dispersive X-ray Spectroscopy. High-resolution Secondary Ion Mass Spectrometry (SIMS) imaging is a well-known technique for the analysis of all elements including isotopes. For this reason, SIMS imaging is used in numerous studies related to Li-ion battery research. While direct imaging of Li in post-mortem battery components is helpful to understand parts of the degradation mechanisms, a complete dynamic view of the evolution of the Li distribution at high resolution during operation (‘ operando ’) of batteries is required to fully understand the local interfacial processes, charge transport characteristics and the degradation mechanisms. A few reports presenting operando Time-of-Flight SIMS imaging of batteries have recently been published [1], but the lateral resolution demonstrated in these reports is not adequate to study local processes that occur at nanoscale. In order to demonstrate operando SIMS chemical imaging with sub-20 nm lateral resolution, we developed a novel operando methodology suitable for Focused Ion Beam (FIB)-SIMS imaging and analysis (see Fig. 1). An in-house designed magnetic-sector mass spectrometer [2] attached to a ThermoFisher SCIOS Ga + FIB is used for SIMS chemical imaging. A special operando sample holder was designed to enable electrochemical cycling of batteries within the FIB-SIMS instrument. The micromanipulator inside the FIB (typically used for preparing thin lamellae for Transmission Electron Microscopy) is used to contact one of the battery electrodes through the operando sample holder and complete the electrical circuit. An external potentiostat is then connected to the instrument to drive the charging/discharging of batteries. The proof-of-concept experiments were performed using Li|Li 7 La 3 Zr 2 O 12 |Li symmetric half-cells. Galvanostatic cycling was performed in-situ inside the FIB-SIMS instrument until the sample failed. SIMS chemical mapping revealed a redistribution of Li during cycling. Lithium rich phases appeared during cycling which likely percolated through grain-boundaries and pores of the solid electrolyte causing a short-circuit failure. These results validate our methodology for operando analysis of Li-ion batteries with the possibility to obtain SIMS chemical images with sub-20 nm lateral resolution [3]. This work was funded by the Luxembourg National Research Fund (FNR) through the grant INTER/MERA/20/13992061 (INTERBATT). [1] Y. Yamagishi, et al., J. Phys. Chem. Lett. 2021, 12, 19, 4623–4627 [2] O. De Castro, et al., Analytical Chemistry, 2022, 94, 30, 10754–10763. [3] L. Cressa, et al., Analytical Chemistry, 2023, under review. Figure 1

Li-S battery analyzed by UV/Vis in operando mode.

In-Operando Optical Imaging of Temporal and Spatial Distribution of Polysulfides in Lithium-Sulfur Batteries

Direct observation of lithium polysulfides in lithium–sulfur batteries using operando X-ray diffraction

Revealing Performance Enhancement Mechanism for Lithium–Sulfur Battery Using In Situ Electrochemical‐Fluorescence Technology

Investigation of the Li-S Battery Mechanism by Real-Time Monitoring of the Changes of Sulfur and Polysulfide Species during the Discharge and Charge

Understanding on Kinetics Change of Li-S Battery with Fluorinated Additives Using in-Situ/Operando Raman and X-Ray Absorption Spectroscopy

Revealing the Sulfur Redox Paths in a Li–S Battery by an In Situ Hyphenated Technique of Electrochemistry and Mass Spectrometry

Enhanced catalysis LiS<sub>3</sub> of radical-to-polysulfide interconversion <i>via</i> increased sulfur vacancies in lithium-sulfur batteries

Direct Observation of the Redistribution of Sulfur and Polysufides in Li–S Batteries During the First Cycle by in Situ X‐Ray Fluorescence Microscopy

Understanding the lithium–sulfur battery redox reactions via operando confocal Raman microscopy

In Situ, Time-Resolved Raman Spectromicrotopography of an Operating Lithium-Ion Battery

Insight into sulfur reactions in Li-S batteries.

Illuminating Polysulfide Distribution in Lithium Sulfur Batteries; Tracking Polysulfide Shuttle Using Operando Optical Fluorescence Microscopy

Revealing the Selective Bifunctional Electrocatalytic Sites via In Situ Irradiated X-Ray Photoelectron Spectroscopy for Lithium-Sulfur Battery

Ex-situ Analysis of Lithium Distribution in a Sulfide-based All-solid-state Lithium Battery by Particle-induced X-ray and Gamma-ray Emission Measurements

In situ monitoring redox processes in energy storage using UV–Vis spectroscopy

In Situ Synchrotron XRD and sXAS Studies on Li-S Batteries with Ionic-Liquid and Organic Electrolytes

Operando Photoelectron Spectroscopy Analysis of Li6PS5Cl Electrochemical Decomposition Reactions in Solid-State Batteries

Quantitative Investigation of Polysulfide Adsorption Capability of Candidate Materials for Li-S Batteries

Towards Operando Secondary Ion Mass Spectrometry Imaging of Lithium Redistribution in Solid-State Lithium-Ion Batteries: Correlation of Structural, Chemical and Electrochemical Characteristics

On the nanoscale structural evolution of solid discharge products in lithium-sulfur batteries using operando scattering