Abstract:(A final version of this paper is published in "International Journal of Rock Mechanics and Mining Sciences") We introduce a peridynamic (PD) model for simulating damage and fracture in porous materials based on an Intermediate Homogenization (IH) approach. In this approach, instead of explicitly representing the detailed pore geometry, we use homogenization but maintain some information about the microstructure (porosity) in the model. Porosity is introduced in the model as initial peridynamic damage, implemented by stochastically pre-breaking peridynamic bonds to match the desired porosity value. We validate the model for elastodynamics with wave propagation in porous glasses, where we match observed wave propagation speeds and the apparent elastic moduli for various porosities. The model is then used to study the fracture behavior of Berea sandstone under three-point bending loading conditions. We validate the model for fracture problems using the case of failure in a sandstone sample with an off-center pre-notch under three-point bending. The IH-PD results agree very well with experiments: we obtain different failure modes depending on the length of the off-center pre-notch. When the pre-notch is short, most damage (and the subsequent failure) happens in the center of the beam (largest tensile stresses in an un-notched sample). In this case, material porosity makes the fracture behavior “insensitive” to the presence of the off-center pre-notch. When the pre-notch is long, damage starts from near its tip, and progresses in mixed mode towards the loading point. The model captures the location of crack initiation to be the right-corner of the notch, exactly as shown by the experimental acoustic emission results. A fully-homogenized model for the porous sandstone fails to reproduce the failure mode sensitivity on the pre-notch length. The results show the importance of using the IH-PD model when trying to capture the important effects local heterogeneities (like pores) have on damage initiation and growth in porous materials.

Peridynamic simulation of fatigue crack growth in porous materials

Strength-induced Peridynamic model for the dynamic failure of porous materials

Peridynamic Simulation of Fatigue Crack Growth Behaviour with the Effect of Microstructure

A peridynamic model for damage and fracture in porous materials

Multiscale Analysis-Based Peridynamic Simulation of Fracture in Porous Media

A State-Based Peridynamic Flexural Fatigue Model for Contact and Bending Conditions

Effects of Gas-Pore Sizes and Locations on Fatigue Failure: A Peridynamic Study

A peridynamic model for brittle damage and fracture in porous materials

Continuum Damage Mechanics Based Approach to the Fatigue Life Prediction of Cast Aluminium Alloy with Considering the Effect of Porosity

Effects of porosity on the fatigue life of polyamide 12 considering crack initiation and propagation

A Peridynamic Model for Structural Fatigue Crack Propagation Analysis under Spectrum Loadings

A thermo-chemo-mechanically coupled peridynamics for investigating crack behavior in solids

Continuum damage mechanics-based model for the fatigue analysis of welded joints considering the effects of size and position of inner pores

A fatigue life prediction approach for porosity defect-induced failures in directed energy deposited Ti-6Al-4V considering crack growth environment

Peridynamic Electromechanical Modeling of Damaging and Cracking in Conductive Composites: A Stochastically Homogenized Approach

A Continuum Damage Model for Multi-Axial Low Cycle Fatigue of Porous Sintered Metals Based on the Critical Plane Concept

Investigations into Gas-Pore Effects on Fatigue Strength with a Peridynamic Approach

Novel Quantification of Porosity Defects on Fatigue Behavior for Cast Aluminum-Silicon Alloys by X-ray Micro-Tomography

Studies on Quasi-Static and Fatigue Crack Propagation Behaviours in Friction Stir Welded Joints Using Peridynamic Theory

A Stochastically Homogenized Peridynamic Model for Intraply Fracture in Fiber-Reinforced Composites

Fatigue crack growth analysis of hydrogel by using peridynamics