Abstract:Ammonia can be stored as a liquid under relatively easy conditions (Ambient temperature by applying 10 bar or Ambient pressure with the temperature of 239 K). At the same time, liquid ammonia has a high hydrogen storage density and is, therefore, a particularly promising carrier for hydrogen storage. At the same time, the current large-scale industrial synthesis of ammonia has long been mature, and in the future, it will be possible to achieve a zero-emission ammonia regeneration cycle system by replacing existing energy sources with renewable ones. Ammonia does not contain carbon, and its use in fuel cells can avoid NO x production during energy release. high temperature solid oxide fuel cells can be directly fueled by ammonia and obtain good output characteristics, but the challenges inherent in high temperature solid oxide fuel cells greatly limit the implementation of this option. Whereas PEMFC has gained initial commercial use, however, for PEMFC, ammonia is a toxic gas, so the general practice is to convert ammonia to pure hydrogen. Ammonia to hydrogen requires decomposition under high temperature and purification, which increases the complexity of the fuel system. In contrast, PEMFC that can use ammonia decomposition gas directly can simplify the fuel system, and this option has already obtained preliminary experimental validation studies. The energy efficiency of the system obtained from the preliminary validation experiments is only 34–36%, which is much lower than expected. Therefore, this paper establishes a simulation model of PEMFC directly using ammonia decomposition gas as fuel to study the maximum efficiency of the system and the effect of the change of system parameters on the efficiency, and the results show that the system efficiency can reach up to 45% under the condition of considering certain heat loss. Increasing the ammonia decomposition reaction temperature decreases the system efficiency, but the effect is small, and the system efficiency can reach 44% even at a temperature of 850°C. The results of the study can provide a reference for a more scientific and quantitative assessment of the potential value of direct ammonia decomposition gas-fueled PEMFC.

Numerical simulation of gas–heat–water distribution characteristics of Ammonia–Hydrogen fuel cell

Numerical studies of liquid water behaviors in PEM fuel cell cathode considering transport across different porous layers

Numerical Modeling of Liquid Water Transport Inside and Across Membrane in PEM Fuel Cells

Simulation and Study of PEMFC System Directly Fueled by Ammonia Decomposition Gas

A single-phase, non-isothermal model for PEM fuel cells

Numerical and Experimental Investigation of the Asymmetric Humidification and Dynamic Temperature in Proton Exchange Membrane Fuel Cell

Numerical Investigation of Transient Responses of a PEM Fuel Cell Using a Two-Phase Non-Isothermal Mixed-Domain Model

Influencing Sensitivities of Critical Operating Parameters on PEMFC Output Performance and Gas Distribution Quality under Different Electrical Load Conditions

Experimentally and Numerically Investigating Cell Performance and Localized Characteristics for a High-Temperature Proton Exchange Membrane Fuel Cell

Effect of cathode relative humidity on membrane water content and performance of PEMFC

Analyzing Key Factors Influencing Water Transport in Open Air-Cooled PEM Fuel Cells

Numerical study of the effect of relative humidity and stoichiometric flow ratio on PEM (proton exchange membrane) fuel cell performance with various channel lengths: An anode partial flooding modelling

Numerical Study of Water Transport and Operating Strategy for Fuel Cells with Segmented Water Management Flow Fields

Performance enhancements of power density and exergy efficiency for high-temperature proton exchange membrane fuel cell based on RSM-NSGA III

Influence of Operating and Electrochemical Parameters on PEMFC Performance: A Simulation Study

CFD investigating the effects of different operating conditions on the performance and the characteristics of a high-temperature PEMFC

Model-Based Performance Optimization of Thermal Management System of Proton Exchange Membrane Fuel Cell

Analysis of Optimal Humidification Characteristics about PEMFC

Numerical Modeling and Performance Prediction of Water Transport for PEM Fuel Cell

Numerical Simulation of Three-Dimensional Gas/liquid Two-Phase Flow in a Proton Exchange Membrane Fuel Cell

Modeling and Experimental Investigation of the Anode Inlet Relative Humidity Effect on a PEM Fuel Cell