Abstract:Dose estimation by electron paramagnetic resonance (EPR) has been accomplished using the standard EPR dosimetry technique (ISO protocol 13304-1 for EPR retrospective dosimetry). However, different studies showed that these techniques have high measurement errors in measuring the low doses (10-100 mGy) in enamel. This work proposes a new method to make a dosimetric signal visible and measurable at low doses. The sample was purified using both chemical and mechanical processes. The pure sample mass and position and the EPR acquisition parameters were optimized to enhance the spectrometer's sensitivity for the quantitative low dose measurements. At the same time to reduce errors from the sample and spectrum anisotropy, the total doses (low plus spike) and the spike dose (4 Gy) were measured by rotating 0 to 360 degrees (i.e., 40 degrees at a time) relative to constant magnetic field direction using a goniometer. Subsequently, the spectra were averaged after their g-factor normalization. However, at low doses (<30 mGy), the radiation induced signal (RIS) was obscured by the background signal (BGS). So, the dose spiking technique was used as an alternative method. Ten low-dose deciduous molar tooth enamel (10-100 mGy) samples were spiked to the higher doses by delivering 4 Gy and measured using the X-band continuous wave (CW) EPR (Bruker EMXmicro) spectrometer. The total dose EPR signal was distinctly visible, and the peak-to-peak (P2P) amplitude height was measured. Then, the total dose was subtracted with the spike, often called a reference sample, to determine the initial low doses. The measurement errors using this method were lower than the previous methods. These results demonstrated that this method could be promising for solving low dose measurement problems in EPR dosimetry with deciduous and permanent tooth enamel.

Precisiong-factor measurements of electron paramagnetic resonance standards

Accurate measurement of g factor in electron spin resonance experiment

Detection of L-band electron paramagnetic resonance in the DPPH molecule using impedance measurements

Accurate Measurements of Crystal Structure Factors Using a FEG Electron Microscope

Peculiarities in Rabi oscillations for fast-relaxing electron spins

Accurate measurement of atomic magnetic moments by minimizing the tip magnetic field in STM-based electron paramagnetic resonance

Dispersion EPR: Considerations for Low-Frequency Experiments

The Effect of the Doppler Mismatch in Microwave Electrometry Using Rydberg Electromagnetically Induced Transparency and Autler–Townes Splitting

Methods for measuring the electron EDM using ultracold YbF molecules

A precision measurement of the electron's electric dipole moment using trapped molecular ions

Filling factor of a paramagnetic sample in a rectangular cavity: theory and application

[22] Electron paramagnetic resonance spectroscopy

Rapid and Precise Determination of Zero-Field Splittings by Terahertz Time-Domain Electron Paramagnetic Resonance Spectroscopy

Precision Measurement of the Hyperfine Structure of the 85rb 6P3/2 State

Measurement of g-factors of ground and excited optical states of Er3+ in YLiF4 and LuLiF4 in zero dc magnetic field by photon echo method

Extending the Range of Distances Accessible by 19 F Electron-Nuclear Double Resonance in Proteins Using High-Spin Gd(III) Labels

The CW-EPR Capabilities of a Dual DNP/EPR Spectrometer Operating at 14 and 7 T

High-Precision Measurement of Rydberg State Hyperfine Splitting in a Room-Temperature Vapour Cell

X-band rapid-scan EPR of samples with long electron spin relaxation times: a comparison of continuous wave, pulse and rapid-scan EPR

The Dose Spiking Technique for Measuring Low Doses in Deciduous Teeth Enamel Using EPR Spectroscopy for Retrospective and Accident Dosimetry

Extending the range of distances accessible by 19F electron-nuclear double resonance in proteins using high-spin Gd(III) labels