Abstract:Lightweight, carbon fibre reinforced composites are often employed for the manufacture of aerospace components due to their good strength to weight ratio. However, due to poor interlaminar strength, composite components are prone to barely visible impact damage, caused by low velocity impacts, during aircraft operation. Guided-wave-based structural health monitoring (SHM) techniques, using a network of distributed sensors, is an important Structural Health Monitoring (SHM) tool for the detection and localization of in-service impact damage in composite structures. However, the material anisotropy of composite laminates influences guided wave propagation and scattering. These anisotropic effects, if unaccounted for, could lead to inaccurate localization of damage, and potential regions of the structure where guided waves cannot propagate with sufficient amplitude, reducing damage sensitivity. Defect characterization can be improved by considering the scattering characteristics of various damage types for the sparse array signal processing. Guided wave scattering (A0 Lamb wave mode) was investigated around an artificial insert delamination in a quasi-isotropic CFRP panel. Permanent magnets, mounted on an undamaged region of the plate, were also used as scattering targets and compared to the delamination case. Full 3D Finite Element (FE) simulations were performed for both the delamination and magnet cases and compared to wavefield data obtained from non-contact laser Doppler vibrometer (LDV) measurements. Individual ply layers were modelled using unidirectional composite material properties to accurately capture the anisotropy effects. Good agreement was found between the experimental measurements and simulations. Scattered guided wave amplitudes around each damage type show strong directional dependency with energy focusing along the fiber directions of the outer ply layers of the laminate. Distinct scattering behavior was observed for each damage type. Implications of anisotropy and angular scattering on sparse array SHM of different defect types are discussed.

Behavior monitoring of flax fiber reinforced composites by guided waves

Static behavior of thick flax/epoxy composite laminates: multi-instrumentation mechanical failure analysis

Multi-scale analysis of the mechanical behaviour of a flax fibre reinforced composite under low-velocity impact

Experimental investigation of failure mechanisms and evaluation of physical/mechanical properties of unidirectional flax–epoxy composites

An Experimental Analysis for Damage Monitoring in Glass Fiber/Epoxy Composites During Fatigue Tests by Acoustic Emission

A Waveform Clustering Method for Damage Mode Identification for Composite Laminates under Hygrothermal Environment

A New Quantitative Acoustic Emission Model for Damage Characterization of Composite Laminates Using Original Waveforms

Modal behavior of post low velocity impact flax/epoxy composite structures

Delamination Analysis of Carbon Fiber/Epoxy Composite Laminates under Different Loading Rates Using Acoustic Emission

In Situ Non-Destructive Stiffness Assessment of Fiber Reinforced Composite Plates Using Ultrasonic Guided Waves

Guided Ultrasonic Wave Monitoring of Damage in Anisotropic Composites

Guided waves in anisotropic and quasi-isotropic aerospace composites: three-dimensional simulation and experiment

Damage investigation of hybrid flax-glass/epoxy composites subjected to impact fatigue under water ageing

Damage Sensing in Natural Fiber/Epoxy Composites

Contribution of field measurements in the study of composites reinforced with flax fibers during quasi-static tensile tests

Theoretical and experimental investigation of circumferential guided waves in orthotropic annuli

Acoustic Emission-Based Analysis of Damage Mechanisms in Filament Wound Fiber Reinforced Composite Tubes

Structural health monitoring of carbon fiber reinforced matrix by the resistance variation method

Mechanical properties and low-velocity impact analysis of camel hair and hybrid camel hair/flax fibre-reinforced epoxy

Experimental and numerical investigation of damage evolution in carbon fiber reinforced polymer stiffened panel in post-buckling regime

Using FGM concept in fiber-matrix coupling laws to predict the damage in carbon-Epoxy graded composite application in notched plate under thermo-mechanical loading