Abstract:The wear of oil pump vanes easily leads to the noise and vibration, even results the decrease of volume efficiency and total efficiency. In order to reduce the friction and improve the lubrication between the vane and the pump inner wall, the micro-machining of micro-structure on the oil pump vanes is proposed. First, the micro-V-grooves with the depth ranging from 500 mu m to 50 mu m were micro-grinding on the top of the vanes by a diamond grinding wheel. Secondly, the experiments were conducted to test the actual flow rate, the output power and the overall efficiency of the oil pump with and without the micro-groove vanes. Then, the computational fluid dynamics (CFD) method was adopted to simulate the pump internal flow field. Finally, the micro-flow field between the internal wall of the oil pump and the top of micro-grooved vanes was analyzed. The results shows that the pump overall efficiency increased as the decrease of micro-groove depth from 500 mu m to 50 mu m and not be affected by the rotate speed and working frequency of the pump rotator. Especially the micro-groove with depth of 50 mu m, the actual flow rate, the output power and the overall efficiency reached to the maximum. From CFD simulation, the velocity of the micro-flow between the surfaces of the vane and inner wall was larger than the pump linear velocity when the microstructure depth is larger than 50 mu m, leading to an internal leakage. When the micro-groove depth is between 10-50 mu m, the velocity of the micro-flow was less than the pump linear velocity and no internal leakage was found, but the oil film thickness is too small to be beneficial to lubrication according to the fluid dynamic characteristics. Thus, for the oil pump equipping with micro-grooved vane with the depth of 50 mu m, the internal leakage not only is avoided but the lubrication efficiency is improved and the oil pump efficiency is also enhanced.

Design of gerotor oil pump with new rotor profile for improving performance

Optimal Design of Gerotor Profile with Lemniscate Lobe Shape for Noise Reduction

Development of a new gerotor for oil pumps with multiple profiles

Design of Gerotor Oil Pump with 2-Expanded Cardioids Lobe Shape for Noise Reduction

Development of Combined Trochoidal Profile of a Gerotor Pump

Influence of rotor profile geometry on the performance of an original low-pressure gerotor pump

Elliptical lobe shape gerotor pump design to minimize wear

Optimization of Gerotor Pumps with Asymmetric Profiles through an Evolutionary Strategy Algorithm

Design of rotor profile of a new roots vacuum pump

Profile Design and Numerical Calculation of Instantaneous Flow Rate of a Gerotor Pump

A newly developed rotor profile for lobe pumps: Generation and numerical performance assessment

A methodology for investigating the influence of hydrodynamic effects in gerotor type positive displacement machines

New design and transient flow analysis of a claw vacuum pump with novel gear-claw rotors

Design of Rotor for Internal Gear Pump Using Cycloid and Circular-Arc Curves

Design and Analysis of a 500W 120000rpm High-Speed Permanent Magnet Motor

The Mechanism Performance of Improved Oil Pump with Micro-Structured Vanes

Rotor profile design in a hypogerotor pump

Numerical Investigation of Influence of Rotor-Rotor Gap on Performances of Contra-Rotating Axial Flow Pump

Geometric design and performance analysis of conical-rotor screw vacuum pump with adjustable flow field clearances

Design and fluid analysis of the microsegment gear tooth profile for pump operating at high speed and high pressure

The Optimization of A Low Specific Speed Pipeline Pump