Abstract:The ejector refrigeration cycle (ERC) is often used as the sub-cycle of power and cooling cogeneration systems due to its advantages of simple structure design, few moving parts, less system investment, good stability and reliable operation. Considering the potential of organic Rankine cycle (ORC) in the utilization of low-grade heat, and the advantages of simple structure and many choices for working fluid, a novel power and cooling cogeneration system was designed, based on dual-pressure evaporation ORC (DORC) and ERC. In this system, a common condenser was used by DORC and ERC, and a part of working fluid separated from low-pressure steam generator outlet in DORC was used as the primary flow of ejector to drive ERC. A mathematical model for calculating the thermodynamic and thermoeconomic performances of the system was established. Sensitivity analysis was performed to determine the key parameters of the system, the results showed that the low-pressure evaporation temperature (TLPSG,out), high-pressure evaporation temperature (THP,E), vapor fraction of the low-pressure steam generator outlet (xLPSG,out) and working fluid mass flow ratio of high-pressure stage to low-pressure stage (k) were the four key parameters of the system. Parametric analysis showed that higher TLPSG,out and lower xLPSG,out were beneficial to increase the cooling output and thermal efficiency, while higher THP,E and larger k were helpful to increase the net power output and exergy efficiency. The net power output and exergy efficiency can be optimized by TLPSG,out and xLPSG,out. Using genetic algorithm (GA), multi-objective function optimization was carried out with THP,E, TLPSG,out, xLPSG,out and k as the decision variables. Moreover, the system's adaptability for working fluids R245fa, R236ea, R600, R600a, R601 and R601a was investigated. According to the optimization results, R236ea was the most suitable working fluid. When THP,E was 402.43K, TLPSG,out was 392.42K, xLPSG,out was 0.357 and k was 0.321, the calculated net power output , cooling output, thermal efficiency, exergy efficiency and total cost of unit exergy product (SUCP) were 273.00kW, 121.80kW, 14.52%, 44.03% and 42.62$/MWh, respectively. Exergy analysis was conducted using R236ea as working fluid. The results showed that the two steam generators and condenser were the main components responsible for most of the exergy destruction of the system in both basic case and optimized case. Compared to the basic case, the exergy destruction of the steam generators decreased by about 32.3%, and the total exergy destruction of the system decreased by about 5.0% in optimized case.

Comparative study on the thermodynamic and economic performance of novel absorption power cycles driven by the waste heat from a supercritical CO2 cycle

Performance Analysis and Evaluation of a Supercritical CO2 Rankine Cycle Coupled with an Absorption Refrigeration Cycle

Preliminary Conceptual Exploration about Performance Improvement on Supercritical CO2 Power System Via Integrating with Different Absorption Power Generation Systems

Theoretical Analysis on Thermodynamic and Economic Performance Improvement in a Supercritical CO2 Cycle by Integrating with Two Novel Double‐Effect Absorption Reheat Power Cycles

Experimental and Numerical Study on Thermal Hydraulic Performance of Trapezoidal Printed Circuit Heat Exchanger for Supercritical CO2 Brayton Cycle

Exergoeconomic analysis of a novel trigeneration system containing supercritical CO2 Brayton cycle, organic Rankine cycle and absorption refrigeration cycle for gas turbine waste heat recovery

Thermodynamic and exergoeconomic analysis of combined supercritical CO2 cycle and organic Rankine cycle using CO2-based binary mixtures for gas turbine waste heat recovery

Techno-economic-environmental evaluation of a combined cooling heating and power system for gas turbine waste heat recovery

Multi-objective optimization of supercritical CO 2 Brayton cycles for coal-fired power generation with two waste heat recovery schemes

Thermodynamic analysis and parametric optimization of a novel S–CO2 power cycle for the waste heat recovery of internal combustion engines

Comparative investigation on the supercritical carbon dioxide power cycle for waste heat recovery of gas turbine

Optimization of CO2 Transcritical Power Cycle (CTPC) for engine waste heat recovery based on split concept

Thermodynamic and thermoeconomic performance analyses and optimization of a novel power and cooling cogeneration system fueled by low-grade waste heat

Comprehensive analysis and thermo-economic optimization of the dry cooling system for supercritical CO 2 power cycle

Thermo-economic analysis of a combined cooling, heating and power system based on carbon dioxide power cycle and absorption chiller for waste heat recovery of gas turbine

Evaluation and optimization of supercritical cycles using CO 2 based mixtures as working fluids: A thermodynamic study

Improvement Design and Analysis of a Supercritical CO2/transcritical CO2 Combined Cycle for Offshore Gas Turbine Waste Heat Recovery

Dynamic performance of the transcritical power cycle using CO2-based binary zeotropic mixtures for truck engine waste heat recovery

Performance improvement of supercritical carbon dioxide power cycles through its integration with bottoming heat recovery cycles and advanced heat exchanger design: A review

Performance Improvement of a Solar-Powered Recompression Supercritical Carbon Dioxide Cycle by Introducing an Ammonia-Water Cooling-Power System

Thermo-economic analysis and multi-objective optimization of supercritical Brayton cycles with CO2-based mixtures