Abstract:In this work, to solve the problem of pipeline blockage caused by the accumulation of hydrate particles and wax particles and to explore the interaction characteristics of adhesive force between gas hydrate particles and wax particles as well as droplets, a high-pressure triaxial mobile device was used to measure the adhesion strength between cyclopentane hydrate particles and different commonly seen phases in the pipeline, including cyclopentane hydrate particles themselves, liquid droplets, and wax crystal particles. These experiments were conducted at different temperatures. The results showed that the adhesion between hydrate and wax particles was decreased with the increase in temperature; this is because the wax is amorphous, the heat absorbed when the temperature rises only increases its average kinetic energy, and the stronger the kinetic energy, the lower its viscosity, resulting in reduced adhesion between particles. Meanwhile, this adhesion was also affected by the concentration of wax. As the wax concentration increased from 1 to 5.32 wt % and then to 8.14 wt %, the adhesion between hydrate and wax particles was first decreased and then increased. This was because when the wax crystal concentration was below 5 wt %, a higher wax molecule concentration meant a more hydrophobic surface, which restricted the formation of a capillary liquid bridge between particles and thus reduced the interforce between wax crystal particles and hydrate particles. When the wax crystal concentration was between 5 and 8 wt %, the change of hydrophobicity was no longer the dominating factor, the increase in wax concentration blocked the hydrate molecular diffusion path, which caused a higher hydrate viscosity, therefore leading to a decreased hydrate molecular diffusion rate and a reduced conversion rate of the liquid bridge in hydrates, the lower conversion rate could subsequently lead to the increasing size of micropores in the hydrate shell, and adhesion between particles was increased.

HYDRATE PARTICLES ADHESION FORCE MEASUREMENTS: EFFECTS OF TEMPERATURE, LOW DOSAGE INHIBITORS, AND INTERFACIAL ENERGY

Interfacial Adhesion Forces of Hydrate Particles in the Presence of Hydrate Inhibitors.

Investigation on the Adhesion Force between Tetrabutylammonium Bromide Hydrate Particles Using Atomic Force Microscopy

Interfacial mechanical properties of tetrahydrofuran hydrate-solid surfaces: Implications for hydrate management

Adhesion strength of tetrahydrofuran hydrates is dictated by substrate stiffness

Effects of Shear Loading Rate on Tetrahydrofuran Hydrate Adhesion Strength for Enhanced Flow Assurance

Microscopic Insights into the Effects of Anti-Agglomerant Surfactants on Surface Characteristics of Tetrahydrofuran Hydrate

High Pressure Micromechanical Force Measurements of the Effects of Surface Corrosion and Salinity on Ch4/C2h6 Hydrate Particle-Surface Interactions

Study on the Adhesion Force between Wax Crystal Particles and Hydrate Particles

Influence of Lateral Velocity on Adhesion Force of Surfaces with Different Hydrophilicity Revealed by an AFM Colloidal Probe at Humid Environments

Surface morphology effects on clathrate hydrate wettability

Micromechanical cohesion force between gas hydrate particles measured under high pressure and low temperature conditions.

Contact time dependence of adhesion force studied at low, moderate, and high relative humidities on AFM: Influence of surface hydrophilicity

Interfacial rheology of cyclopentane hydrate formation: Insights into mechanical behavior and inhibitor efficiency

The Adhesion Strength of Semi-Clathrate Hydrate to Different Solid Surfaces

Direct measurements of interfacial adhesion in 2D materials and van der Waals heterostructures in ambient air

Influence of AFM Tip Temperature on THF Hydrate Stability: Theoretical Model and Numerical Simulation

Effects of Additive Mixture (THF/SDS) on the Thermodynamic and Kinetic Properties of CO2/H2 Hydrate in Porous Media

Research progress on micro-force measurement of a hydrate particle system

Clathrate Hydrate-Solid Surface Adhesive Shear Strength Measurements on Carbon Steel Surfaces

Interactions of clathrate hydrate promoters sodium dodecyl sulfate and tetrahydrofuran investigated using 1H diffusion nuclear magnetic resonance at hydrate-forming conditions