Abstract:Direct conversion receiver (DCR) architecture is a promising candidate in the radio frequency (RF) front end because of its low power consumption, low cost and ease of integration. However, flicker noise and direct current (DC) offset are large issues. Owing to the local oscillator (LO) frequency, which is half of the RF frequency, and the absence of a DC bias current that introduces no flicker noise, the subharmonic passive mixer (SHPM) core topology front end overcomes the shortcoming effectively. When more and more receivers (RX) and transmitters (TX) are integrated into one chip, the linearity of the receiver front end becomes a very important performer that handles the TX and RX feedthrough. Another reason for the requirement of good linearity is the massive electromagnetic interference that exists in the atmosphere. This paper presents a linearity-improved RF front end with a feedforward body bias (FBB) subharmonic mixer core topology that satisfies modern RF front end demands. A novel complementary derivative superposition (DS) method is presented in low noise amplifier (LNA) design to cancel both the third- and second-order nonlinearities. To the best knowledge of the authors, this is the first time FBB technology is used in the SHPM core to improve linearity. A Volterra series is introduced to provide an analytical formula for the FBB of the SHPM core. The design was fabricated in a 0.13 μm complementary metal oxide semiconductor (CMOS) process with a chip area of 750 μm × 1270 μm. At a 2.4 GHz working frequency, the measurement result shows a conversion gain of 36 dB, double side band (DSB) noise figure (NF) of 6.8 dB, third-order intermodulation intercept point (IIP3) of 2 dBm, LO–RF isolation of 90 dB and 0.8 mW DC offset with 14.4 mW power consumption at 1.2 V supply voltage. These results exhibit better LO–RF feedthrough and DC offset, good gain and NF, moderate IIP3 and the highest figure of merit compared to the state-of-the-art publications.

A Microwave Front-End Nonlinearity Distortion Compensation Method for Digital RF Receivers

A Frequency-Domain I/Q Imbalance Calibration Algorithm for Wideband Direct Conversion Receivers Using Low-Cost Compensator.

Behavioral Modeling of Direct-Conversion Receivers for Nonlinear Distortion Mitigation

A Low-Power Low-Noise Direct-Conversion Front-End with Digitally Assisted IIP2 Background Self Calibration

An Effective DC Offset Calibration Method Combined with Analog and Digital Circuits for Direct Conversion Receivers

A High-Linearity 7–9-Ghz Receiver Front End with Strength-Oriented Nonlinearity Cancellation

Low SNR FMCW Signal Processing with Prior Information.

High-Efficiency Mitigation of Nonlinear Distortion in Microwave Photonics Link Assisted by Artificial Neural Network

Photonic Receiving and Linearization of RF Signals with Improved Spurious Free Dynamic Range

A novel phase-noise compensation scheme for communication receivers

Pre-distortion Compensation for Optical-Based Broadband LFM Signal Generation System

RF-IF Downconversion and Linearization of an Analog Photonic Link Based on Digital Signal Post-Compensation

High-Relative-Bandwidth Multiband LNA Distortion Elimination With Neural Network

Effect of Nonlinearities in Wireless Communication with Digital Receiver

Linearization Techniques in Radio-Over-Fiber Systems

A Linearity Improvement Front End with Subharmonic Current Commutating Passive Mixer for 2.4 GHz Direct Conversion Receiver in 0.13 Μm CMOS Technology

Research in Nonlinearity of Surface Acoustic Wave Devices

Sparse Digital Cancellation of Receiver Nonlinear Distortion in Carrier Aggregation Systems

Analog radio-over-fiber links with a high SFDR for passive distributed antenna system applications using Lagrange multiplier optimization

Compensation of Nonlinear Distortion Using a New Method Combining Predistortion with Reconstruction in OFDM Systems

Pre-compensation of Mach-Zehnder modulator nonlinearity for DD-OFDM system