Abstract:The carbon isotopic composition of CO2 is traced to its different origins and widely used in the fields of geology, biology, and chemistry. Raman spectroscopy can be performed in situ, is nondestructive, and requires no sample preparation; these characteristics enable Raman spectroscopy to be considered a new alternative method to measure the carbon isotopic composition of CO2. In this work, Raman spectra of high-purity 13CO2, 12CO2, and six 12CO2-13CO2 binary mixtures with known mixing ratios were collected using a High Pressure Optical Cell (HPOC) at 50-450 °C and 50-400 bar. The results showed that the characteristic peak positions of both 13CO2 and 12CO2 shift to lower wavenumbers with increasing temperature and decreasing pressure, but the peak positions of 13CO2 show a larger shift. The peak position difference of the corresponding characteristic peaks between 13CO2 and 12CO2 is greater than 15 cm-1 under the above temperatures and pressures, and the peaks can be distinguished. However, ν-13 overlays νH.B.12 near 1265 cm-1, ν+12 overlaps νH.B.13 near 1288 cm-1. The existence of 13CO2 can cause a change in the Fermi diad splitting of 12CO2 and affect the establishment of CO2 Raman densimeters. The positive correlation obtained between the peak intensity ratio and the content ratio is affected by temperature, pressure, and 13CO2 content. I+13/I+12 and I-13/I-12 were selected as the quantitative indices to establish Raman quantitative analysis models for the determination of the carbon isotopic composition of CO2, which can be applied to in-situ measurements of high-temperature and high-pressure systems.

Measurement of CO 2 Isotopologue Ratios Using a Hollow Waveguide-Based Mid-Infrared Dispersion Spectrometer

A Laser-Locked Hollow Waveguide Gas Sensor for Simultaneous Measurements of CO2 Isotopologues with High Accuracy, Precision, and Sensitivity

Simultaneous Measurements of CO and CO2 Employing Wavelength Modulation Spectroscopy Using a Signal Averaging Technique at 1.578 μm

Simultaneous detection of atmospheric CO2 and H2O using a DFB diode laser based absorption spectrometer

Raman spectral characteristics of 12CO2/13CO2 and quantitative measurements of carbon isotopic compositions from 50 to 450 °C and 50 to 400 bar

Development of a quantum cascade laser absorption spectrometer for simultaneous measurement of 13C–18O and 18O–18O clumping in CO2

A compact NIR fiber-optic diode laser spectrometer for CO and CO(2): analysis of observed 2f wavelength modulation spectroscopy line shapes

Measurements of CO2 Temperature and Concentration in High Temperature Environment Based on Tunable Diode Laser Absorption Spectroscopy

Mid‐infrared dissolved CO2 measurement system using the ultra‐compact multipass cell

Measurement of CO2 by Wavelength Modulated Reinjection Off-Axis Integrated Cavity Output Spectroscopy at 2 μm

Measurement of the D/H, 18O/16O, and 17O/16O Isotope Ratios in Water by Laser Absorption Spectroscopy at 2.73 μm

Development and Metrological Characterization of a Tunable Diode Laser Absorption Spectroscopy (TDLAS) Spectrometer for Simultaneous Absolute Measurement of Carbon Dioxide and Water Vapor

Line intensities of CO near 1560 nm measured with absorption and dispersion spectroscopy

Mid-infrared carbon isotope spectrum logging system combined with a thermostat of optical subsystem for high-precision detection of isotope ratio

Near-Infrared Dual-Comb Spectroscopy of CO 2 and N 2 O with a Discretized Highly Nonlinear Fiber

Simultaneous Remote Sensing of Multiple Atmospheric Gases (CO2, CH4, and H2O) Based on an All-Fiber Laser Heterodyne Spectroradiometer

High Precision Calibration of Spectral Parameters of CO at 1567 Nm Based on Wavelength Modulation-Direct Absorption Spectroscopy

Frequency division multiplexing and wavelength stabilized 2f/1f wavelength modulation spectroscopy for simultaneous trace CH4 and CO2 detection

Sub-ppm CO Detection in a Sub-Meter-long Hollow-Core Negative Curvature Fiber Using Absorption Spectroscopy at 2.3 Μm

An ultra-compact CO2 isotope analyzer exclusively based on quantum cascade technology

Sensitive Carbon Monoxide Detection Based on Light Induced Thermoelastic Spectroscopy with a Hollow Waveguide and 2.3 Μm Diode Laser