Abstract:<p>It is usually deformed severely for thin-walled workpiece when the fixture is removed after machining, which is mainly caused by the redistribution of internal stress and machining induced residual stress (MIRS). Previous works have tried to relax the fixture in-processes to release the residual stresses (i.e. internal stress and MIRS), and perform the following machining operation after re-fasten the workpiece at its totally relaxed state. However, the totally relaxed state is only an equilibrium of residual stresses and the MIRS on the top layer of the workpiece will be changed after the following machining process. The residual stresses of the workpiece become imbalance again and thus will lead to the deformation of final component. In this paper, a novel research work of actively controlling the in-processes deformation of thin-walled part is presented, which is aimed at balancing the internal stress/MIRS and preventing the redistribution of residual stresses after last machining step. Firstly, the variations of internal stress, MIRS and clamping force during machining are analyzed through a simplified in-process model of blade. An equilibrium equation is established by taking the residual stresses as the equivalent loads of clamping point. Next, to achieve the proposed in-processes active control method, a mathematical model of how to actively adjust the fixture between machining operations is established. And then, the finite element method (FEM) is used to calculate the MIRS induced deformation, in which the MIRS is measured through experiment. A prototype of active control fixture for blade part is developed to adjust the in-process deformation. Finally, three groups of machining experiments on a simplified blade with three different treatments on the fixture after the rough machining – no relaxing the fixture at all, totally relaxing the fixture in-process, and actively controlling the deformation in-process– are carried out. The validation demonstrates that the proposed in-process active control method could decrease machining deformation significantly. The maximum deformation reduced to 18.3 % and 42.9 % compare to the no relaxing and totally relaxing the fixture after rough milling.</p>

Alternative flexible correction forming of a blade: multipoint correction with surface measurement and deformation simulation

An adaptive approach to error compensation by on-machine measurement for precision machining of thin-walled blade

Mould Correction for Sheet-Metal Multi-Step Incremental Air-Bending Forming Based on Close-Loop Control and FEM Simulation

A self-adaptive auxiliary fixture for deformation control in blade machining

Adaptive CNC Machining Process Optimization of Near- Net- Shaped Blade Based on Machining Error Data Flow Control

Worn area modeling for automating the repair of turbine blades

Machining Fixture for Adaptive CNC Machining Process of Near-Net-shaped Jet Engine Blade

A Positioning Correction Method for Turbine Blade Film Cooling Holes

Tool path modification based on deformation mapping relationship for the adaptive machining of aero-engine blade

Adaptive Positioning Technology of Film Cooling Holes in Hollow Turbine Blades

Clamping Error Calibration Algorithm of Aero-Engine Blade Surface Polishing

Modeling and Performance Analysis of Machining Fixture for Near-Net-shaped Jet Engine Blade

Springback compensation of multiple-step incremental air-bending forming of sheet-metal

BROKEN AREA MODELING FOR REPAIR AUTOMATION

Construction method of process model for correcting local profile errors of turbine blades

Research on adaptive CNC machining arithmetic and process for near-net-shaped jet engine blade

A Real-Time Measuring Technology for Studying Distortion of Hydraulic Turbine Blade Castings During Heat Treatment Process

Accurate Model Construction of Deformed Aero-Engine Blades for Remanufacturing

Machining fixture and deformation control of aero-engine thin-walled casing

A new in-processes active control method for reducing the residual stresses induced deformation of thin-walled parts

Analysis and optimization of the machining fixture system stiffness for near-net-shaped aero-engine blade