Abstract:De-icing roads is a complex process that requires careful consideration of multiple factors, as traditional de-icing methods can have significant environmental and economic impacts. Therefore, the use of sustainable methods such as renewable energy, can potentially help to mitigate some of these issues. In order to investigate this concept, a thorough investigation into the use of hydro-geothermal energy from a tunnel drainage system for preventing the accumulation of ice and snow on traffic areas at the tunnel portals was conducted. As part of this investigation, a pilot system consisting of nine fields with underlying heat pipes was constructed being monitored by several temperature sensors and further equipment. The fields utilise the readily available mountain water from the 1.284 m long road tunnel ́Füssen ́ at the German/Austrian border as a natural heat source [1], eliminating the need for a heat pump. The sensor readings were then compared to the results obtained from a coupled hydro-thermal numerical model (Figure 1). The model considers all heat fluxes acting on the free surfaces (e.g. short and long-wave radiation), and determines the heat flux density required to keep the ice and snow free by means of the energy balance formed at the surface of the field. The validation of the simulation is carried out on the basis of the measurement data which were recorded in periods in which the external atmospheric boundary conditions can be determined as precisely as possible.A parameter study was also conducted that included different weather conditions, variable field geometry, pipe materials, and surface materials such as concrete, or asphalt, as well as the minimum field activation times, the results of these studies confirmed, among other things, that the utilization of copper pipes results in higher temperatures on the surface of the road [2]. Furthermore, it was determined that an activation time of 9 hours prior to the forecast of a weather event is sufficient to raise the temperature of the road surface to remain ice-free. The results of this study provide compelling evidence for the efficacy of the direct, passive outdoor temperature control concept in mitigating snow and ice accumulation on traffic areas adjacent to tunnel portals. This pioneering approach not only safeguards winter safety by maintaining hazard-free surfaces but also presents the opportunity to extend the lifespan of the traffic areas through the implementation of cooling strategies during the summer season. Notably, upon activation, the road surface consistently achieves the necessary temperature to effectively melt snow and ice during moderately intense snowfall within a relatively short timeframe of approximately 5 to 9 hours. These results highlight the practical viability and efficiency of the direct, passive outdoor temperature control method in combatting snow and ice-related challenges. It was concluded that the findings of this study have yielded positive results and have served as proof of concept for the utilization of hydro-geothermal energy from tunnel drainage systems but also from other sources as e.g. BHE as a viable means of preventing ice and snow accumulation on roads. The data obtained from numerical simulations and measurements were found to be in agreement. This method holds the potential to greatly enhance the safety and accessibility of roads during the winter months, while also reducing the dependence on traditional de-icing methods that can have detrimental environmental impacts, on top of that, the method has an added benefit of being used in the summer to cool down the roads to prevent heat deformations. The results of this pilot project provide a foundation for further research and development in this field, with the ultimate goal of implementing this technology on a larger scale.

Prevention of preferential bridge icing using heat pipes. Executive summary August 1975--September 1976

Feasibility study of a new attached multi-loop CO2 heat pipe for bridge deck de-icing using geothermal energy

Reduce Bridge Icing by Improving the Bridges' Surface Thermal Emissivity.

De-icing Test of the Externally Heated Geothermal Bridge in Texas

FEASIBILITY STUDY ON BRIDGE DECK COOLNG SYSTEM USING NATURAL GROUND COOLING ENERGY

Experimental on Thermal Performance of Bridge Deck with Hydronic Heating System

A novel full-scale external geothermal heating system for bridge deck de-icing

Study on the Snow- Melting Model Based on Hydronic Heating for Bridge Deck

Temporal and Spatial Thermal Performance of A Ground Heat Exchanger in Response to Bridge Solar Recharging and Deicing Operations: A Pilot Full-Scale Study

Heating performance of a novel externally-heated geothermal bridge de-icing system: field tests and numerical simulations

Investigating the use of hydro-geothermal energy from tunnel drainage system for de-icing roads: results from a pilot study

Field Tests on the Prediction of Heating Power Requirements for Deicing in Jiangyin, China

Development of Probabilistic Temperature Loadsfor a PC Bridge in Oklahoma

Temperature distribution of asphalt bridge deck pavement with groundwater circulation temperature control system under high- and low-temperature conditions

Comprehensive evaluation of thermally conductive functional layer on snow-melting performance for electric heating bridge system

Modeling and analysis of ice condensation on bridge deck pavement surface based on heat transfer theory and finite element method

Sensitivity Analysis of Different Factors in the New Pipe Curtain Freezing Method under Seepage Conditions

TEMPERATURE DISTRIBUTION CHARACTERISTIC IN SOLAR-GROUND SOURCE COUPLED SNOW-MELTING SYSTEM FOR BRIDGE DECK

Performance of a Geothermal Energy Deicing System for Bridge Deck Using a Pile Heat Exchanger

APPLICATION STUDY OF GEOTHERMIC HEAT PIPE SNOW MELTING SYSTEM

Freezing Effect of Enhancing Tubes in a Freeze-Sealing Pipe Roof Method based on the Unsteady-State Conjugate Heat Transfer Model