Abstract:At present, the interest in non-Pd hydrogen permeation membranes mainly focuses on group 5 B metals (Nb, V, Ta) and their alloys. To solve the problem of easy oxidation and weak dissociation of hydrogen molecules, a "Pd catalytic layer" needs to be deposited on the membrane surface. Due to its limited stability towards sulfur, issues of irreversible poisoning by sulfur compounds must be addressed. To this end, Pd-, Pd 65 Ag 35 -, Pd 90 Cu 10 -, Pd 80 Au 20 -, and Pd 55 Ag 35 Au 10 -coated Nb 30 Hf 35 Co 35 membranes were firstly synthesised by magnetron sputtering, and their hydrogen permeation behaviour in pure H 2 and/or in different H 2 /H 2 S mixtures for up to 1000 ppm at 673 K were evaluated. At these conditions, the permeabilities of the Pd-coated membranes decrease rapidly with increasing the H 2 S concentration and cannot recover after removal of H 2 S from the feed mixtures. In comparison, the Pd–Ag-containing membrane greatly increases the pure H 2 permeability, whereas the membrane doped with Au can effectively improve the response to H 2 S. Specifically, the Pd 65 Ag 35 -coated membrane shows the highest pure H 2 permeability, but it loses maximum permeability value on exposure to H 2 /H 2 S feed mixtures. In contrast, Pd 80 Au 20 -containing membranes exhibit good tolerance of H 2 S poisoning and displayed a high fractional recovery (∼83%) of initial H 2 permeability. The degradation of permeability for Pd- or Pd 65 Ag 35 -coated membranes after the H 2 S exposure can be ascribed to the deterioration of the structure caused by the possible formation of bulk Pd 4 S, which has been corroborated with EDS analysis, XRD, and XPS after testing. Finally, to improve both permeability and chemical tolerance, a Pd 55 Ag 35 Au 10 -coated membrane was successfully fabricated, and it possesses excellent comprehensive performance with respect to the permeability and H 2 S response. At 120 ppm H 2 S in the feed, the H 2 flux equals ca. 43% of its original value at 673 K and can be stable for at least 166 h. Bulk sulfides did not form on the membrane surface after the testing. This paper not only developed a new type of group 5 B alloy membrane with improved resistance to corrosion by H 2 S, but also further confirmed the feasibility of improving H 2 S corrosion resistance by adjusting the catalytic layer type or composition of the outermost coating.

Palladium–lead alloys for the purification of hydrogen-containing gas mixtures and the separation of hydrogen from them

INVESTIGATION OF GAS TRANSMISSION CHARACTERISTICS OF THIN-FILM MEMBRANE MATERIALS BASED ON PALLADIUM ALLOYS

Alloys based on Group 5 metals for hydrogen purification membranes

Palladium-copper membrane prepared by electroless plating for hydrogen separation at low temperature

Studies on the Preparation of Pd/Alumina/Porous Stainless Steel Membranes for Hydrogen Separation

High-Performance Hydrogen-Selective Pd-Ag Membranes Modified with Pd-Pt Nanoparticles for Use in Steam Reforming Membrane Reactors

First-principles evaluation of Pd–Pt–Ag and Pd–Pt–Au ternary alloys as high performance membranes for hydrogen separation

Recent Advances in Pd-Based Membranes for Membrane Reactors

Resistivity testing of palladium dilution limits in CoPd alloys for hydrogen storage

V–Ni alloy membranes for hydrogen purification

Review of Supported Pd-Based Membranes Preparation by Electroless Plating for Ultra-Pure Hydrogen Production

Highly efficient and direct recovery of low-pressure hydrogen isotopes from tritium extraction gas by PdY alloy membrane permeator

Improved the H2S corrosion resistance for Nb30Hf35Co35 alloy by modifying surface catalytic layer

A new palladium alloy with near-ideal hydrogen storage performance

Development of Nb-based alloy membranes with improved resistance to corrosion by H 2 S

Microstructures of Directionally Solidified Nb15Ti55Fe30 Alloy and Its Hydrogen Permeation Properties in the Presence of H2S

Collectable Single Pure-Pd Metal Membrane with High Strength and Flexibility Prepared through Electroplating for Hydrogen Purification

Optimization analysis of hydrogen separation from an H2/CO2 gas mixture via a palladium membrane with a vacuum using response surface methodology

Hydrogen storage alloys for high-pressure suprapure hydrogen compressor

Mechanisms of formation and shape control of pentagonal Pd-nanostars and their unique properties in electrocatalytic methanol oxidation and membrane separation of high-purity hydrogen

Palladium-based membranes for potential application in bio-jet fuel production unit