Palladium-based membranes for potential application in bio-jet fuel production unit

Ritu Parashar,Bipin Chandra Nailwal,Nitesh Goswami,Raja Kishora Lenka,Amit Kumar Singha,Soumitra Kar,Asis Kumar Adak,Suresh Chandra Parida,Sulekha Mukhopadhyay
DOI: https://doi.org/10.1080/00194506.2023.2232386
2023-07-21
Indian Chemical Engineer
Abstract:The hydrogen in the vent gas stream of the hydrocracker (used to produce bio-jet fuel) cannot be reused since it has many impurities. The metal membrane can be a potential candidate for recovering hydrogen from this vent gas. In this work, the authors report the development of a composite palladium membrane and its application, for the first time, in the recovery of hydrogen from a simulated vent gas environment. A dense thin film (thickness ∼3 μm) of Pd metal was coated on a ceramic support tube by the sputter deposition technique. The hydrogen permeance of the Pd membrane was found to be 18.75 × 10 −6 mol·m −2 ·h −1 ·Pa −1 , which was reduced to 3.25 × 10 −6 mol·m −2 ·h −1 ·Pa −1 , with an exposure of 100 h in the simulated bio-jet fuel environment. To avoid the loss of permeability, a thin layer of Pt can be coated over the Pd membrane. The present study used MATLAB software to simulate the Pt-coated Pd composite membrane performance in the bio-jet fuel production environment. Simulation studies confirmed that a membrane area of ∼95 cm 2 (250 mm length and 12 mm OD) is sufficient for the complete recovery of hydrogen from the vent gas stream of hydrocracker at a feed velocity of 0.075 m/s. GRAPHICAL
What problem does this paper attempt to address?