Abstract:Powdered Ni-based catalysts exhibit good performance in the dry reforming of methane (DRM); however, they suffer from limited industrial applicability. Structured monolithic catalysts can overcome these limitations. In this sense, we present the synthesis of Ni–Ce mixed oxide-type catalysts immobilized in cordierite monoliths using a simple coprecipitation method and slurry coating without additives using hydrotalcite precursors for catalyst preparation. Our research explores the role of Ce (0–7 % w/w) as a promoter and the impact of immobilizing mixed oxides (MO) within cordierite monoliths on the physicochemical properties and catalytic performance of non-previously H 2 -reduced materials in DRM at 700 °C. Our findings reveal the favorable impact of Ce on the physicochemical properties of the catalyst in both the powder and monoliths, including smaller crystallite sizes, enhanced CO 2 adsorption, and reducibility with higher Ce loading. The immobilized mixed oxide (MO) maintained its crystalline structure and formed stable, uniform layers with thicknesses below 10 μm in the monoliths. The powders exhibited stable conversions of 70–80% for CH 4 and 66–75% for CO 2 , whereas the monoliths showed conversions of 85–90% for CH 4 and 80–90% for CO 2 at 700 °C and 94,680 mL·g cat −1 ·h −1 . A higher catalyst loading in the monoliths did not result in detrimental catalytic conversion. On average, the monoliths had a higher H 2 /CO ratio (1.25–1.5) compared to the powders (1–1.25), which may explain the increased coke formation rate in the monoliths from methane cracking. Ce improved the stability and reduced coke formation, particularly when the space velocity was lower. This research highlights the significant advantages of immobilizing mixed oxides (MO) in monolithic structures, making them highly promising for potential industrial scale-up. Their stability, recoverability, elimination of high-cost H 2 reduction, and reusability in subsequent catalytic tests contributed to their favorable characteristics.

Influence of Mn, Mg, Ce and P promoters on Ni-X/Al2O3 catalysts for dry reforming of methane

Improving Catalytic Stability and Coke Resistance of Ni/Al2O3 Catalysts with Ce Promoter for Relatively Low Temperature Dry Reforming of Methane Reaction

Highly dispersed Ni/MgO-mSiO2 catalysts with excellent activity and stability for dry reforming of methane

Ni/x%Nb2O5/Al2O3 Catalysts Prepared via Coprecipitation-Wet Impregnation Method for Methane Steam Reforming

Role of promoter on the catalytic activity of novel hollow bimetallic Ni–Co/Al 2 O 3 catalyst in the dry reforming of methane process: Optimization using response surface methodology

Methane dry reforming over nickel-based catalysts: insight into the support effect and reaction kinetics

Engineering of Surface Properties of Ni-CeZrAl Catalysts for Dry Reforming of Methane

Bimetallic NiFe Nanoparticles Supported on CeO2 as Catalysts for Methane Steam Reforming

Promoted Nickel–Cobalt Bimetallic Catalysts for Biogas Reforming

Advancements in Methane Dry Reforming: Investigating Nickel–Zeolite Catalysts Enhanced by Promoter Integration

Highly dispersed Ni/Al2O3 catalysts for dry reforming of methane prepared by alkaline-induced adsorption process

Dry Reforming of Methane over Mn-modified Ni-based Catalysts

Enhanced activity and stability of Ce-doped PrCrO3-supported nickel catalyst for dry reforming of methane

Combined Steam and CO2 Reforming of Methane over Ni-Based CeO2-MgO Catalysts: Impacts of Preparation Mode and Pd Addition

Effects of Promoters and Preparation Procedures on Reforming of Methane with Carbon Dioxide over Ni/Al2O3 Catalyst

Dry reforming of methane over Mn-Ni/attapulgite: Effect of Mn content on the active site distribution and catalytic performance

Dry reforming of methane using cordierite monoliths with immobilized Ni–Ce catalysts

Modulating Proportion of Ni0 Species Stabilized by Ni2+ on Ni-MgO Catalyst with Superior Stability for Dry Reforming of Methane

Highly Coke Resistant Mg- Ni/ Al2O3 Catalyst Prepared Via a Novel Magnesiothermic Reduction for Methane Reforming Catalysis with CO2: the Unique Role of Al- Ni Intermetallics

Rational design of nickel-based catalyst coupling with combined methane reforming to steadily produce syngas

Highly Dispersed Ni Nanoparticles Supported by Porous Al2O3 Rods for Catalytic Dry Reforming of Methane