Abstract:Thin-film composite (TFC) membranes are attracting wide attention because their ultrathin selective layer usually corresponds to the higher membrane flux for pervaporation. However, the direct preparation of the TFC membranes on ceramic substrates confronted with the great difficulties because the larger pores on ceramic substrate surfaces are detrimental to the formation of an intact polyamide (PA) selective layer produced by interfacial polymerization (IP) reaction. Here, the integrated ZIF-L nanosheets were proposed to be used as an assistance interlayer for the first time to eliminate the existence of the pores of the ceramic support, and provides a better basis for the formation of an intact PA selective layer by IP reaction between TMC and ethylenediamine (EDA). The experimental data obtained in pervaporation (PV) show that the increased flux from 1.1 to 2.9 kg/m2h corresponds to the decreased separation factor from 396 to 110 when the feed concentration of ethanol decreases from 95 wt % to 80 wt % at 50 °C. In addition, the membrane flux increases from 0.8 to 2.5 kg/m2h with a change of the separation factor from 683 to 111 when the operational temperature varies from 30 to 60 °C. These results demonstrate the great potential of the fabricated TFC membranes in practical application for PV dehydration of organic solutions.(PDF) The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c09221.Figure S1, schematic diagram of vacuum filtration process; Figure S2, schematic diagram of vacuum filtration process for removing redundant EDA solution; Figure S3, SEM images and XRD patterns of alumina support with ZIF-L nanosheets in ref 34; Figure S4, X-ray diffraction patterns of the ZIF-L nanosheet on the ceramic support without (and with) 1.0 wt % EDA treatment; Figure S5, surface and cross-section images of the ceramic support with EDA treated ZIF-L nanosheets; Figure S6, IP mechanism of the PA layer produced by the reaction between EDA and TMC; Table S1, comparison of separation performance of the TFC membranes for the dehydration of ethanol–water mixtures (PDF)This article has not yet been cited by other publications.

Stitch and copolymerization of thin-film composite membranes to enhance hydrophilicity and organics resistance for the separation of glycerol-based wastewater

Fabrication of Ph-Sensitive Superhydrophilic/Underwater Superoleophobic Poly(vinylidene Fluoride)-Graft-(sio2 Nanoparticles and PAMAM Dendrimers) Membranes for Oil-Water Separation.

Preparation of Reverse Osmosis Composite Membrane with High Flux by Interfacial Polymerization of Mpd and Tmc

Enhanced pervaporation dehydration performance of polyamide thin‐film composite membrane with sodium alginate hydrophilic surface modification

Preparation and Properties of Cellulose Triacetate (CTA)-PVDF Composite Membrane with Hydrophobic/hydrophilic Properties for Membrane Distillation

Zwitterionic Polyamide Membranes Via In-Situ Interfacial Polymerization Modification for Efficient Pervaporation Dehydration

Vapor‐phase Polymerization of High‐performance Thin‐film Composite Membranes for Nanofiltration

Molecular design of thin film composite (TFC) hollow fiber membranes for isopropanol dehydration via pervaporation

Thin-film composite membranes fabricated directly on a large-porous ceramic support using poly (4-styrenesulfonic acid) as a scaffold for ethanol dehydration

LDHs/TA-modified hybridized PAN/PVDF-HPF electrospinning membrane for emulsion separation

Mutual-assisted structure of sodium alginate-polyamide membrane for high-efficient dehydration of ethanol

Template-assisted preparation of conjugated microporous polymers membranes for selective separation

Tailoring ultrathin microporous polyamide films with rapid solvent transport by molecular layer-by-layer deposition

Surface synthesis of a polyethylene glutaraldehyde coating for improving the oil removal from wastewater of microfiltration carbon membranes

Thin-Film Composite Membrane Prepared by Interfacial Polymerization on the Integrated ZIF-L Nanosheets Interface for Pervaporation Dehydration

Preparation of Composite Membrane by Plasma-graft Polymerization and Its Pervaporation Properties for Removing Chlorinated Organics from Water

Molecular Design of the Polyamide Layer Structure of Nanofiltration Membranes by Sacrificing Hydrolyzable Groups Toward Enhanced Separation Performance.

Constructing a Hierarchical Hydrophilic Crosslink Network on the Surface of a Polyvinylidene Fluoride Membrane for Efficient Oil/Water Emulsion Separation

Improved pervaporation efficiency of thin-film composite polyamide membranes fabricated through acetone-assisted interfacial polymerization

A Facile and Scalable Fabrication Procedure for Thin-Film Composite Membranes: Integration of Phase Inversion and Interfacial Polymerization.

Preparation and characterization of novel thin film composite nanofiltration membrane with PVDF tree-like nanofiber membrane as composite scaffold