Abstract:Thin-film composite (TFC) membranes are attracting wide attention because their ultrathin selective layer usually corresponds to the higher membrane flux for pervaporation. However, the direct preparation of the TFC membranes on ceramic substrates confronted with the great difficulties because the larger pores on ceramic substrate surfaces are detrimental to the formation of an intact polyamide (PA) selective layer produced by interfacial polymerization (IP) reaction. Here, the integrated ZIF-L nanosheets were proposed to be used as an assistance interlayer for the first time to eliminate the existence of the pores of the ceramic support, and provides a better basis for the formation of an intact PA selective layer by IP reaction between TMC and ethylenediamine (EDA). The experimental data obtained in pervaporation (PV) show that the increased flux from 1.1 to 2.9 kg/m2h corresponds to the decreased separation factor from 396 to 110 when the feed concentration of ethanol decreases from 95 wt % to 80 wt % at 50 °C. In addition, the membrane flux increases from 0.8 to 2.5 kg/m2h with a change of the separation factor from 683 to 111 when the operational temperature varies from 30 to 60 °C. These results demonstrate the great potential of the fabricated TFC membranes in practical application for PV dehydration of organic solutions.(PDF) The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c09221.Figure S1, schematic diagram of vacuum filtration process; Figure S2, schematic diagram of vacuum filtration process for removing redundant EDA solution; Figure S3, SEM images and XRD patterns of alumina support with ZIF-L nanosheets in ref 34; Figure S4, X-ray diffraction patterns of the ZIF-L nanosheet on the ceramic support without (and with) 1.0 wt % EDA treatment; Figure S5, surface and cross-section images of the ceramic support with EDA treated ZIF-L nanosheets; Figure S6, IP mechanism of the PA layer produced by the reaction between EDA and TMC; Table S1, comparison of separation performance of the TFC membranes for the dehydration of ethanol–water mixtures (PDF)This article has not yet been cited by other publications.

Enhanced pervaporation dehydration performance of polyamide thin‐film composite membrane with sodium alginate hydrophilic surface modification

Novel Thin-Film Composite Pervaporation Membrane with Controllable Crosslinking Degree for Enhanced Water/alcohol Separation Performance

Zwitterionic Polyamide Membranes Via In-Situ Interfacial Polymerization Modification for Efficient Pervaporation Dehydration

Mutual-assisted structure of sodium alginate-polyamide membrane for high-efficient dehydration of ethanol

Molecular design of thin film composite (TFC) hollow fiber membranes for isopropanol dehydration via pervaporation

Thin-film Composite Membranes with Modified Polyvinylidene Fluoride Substrate for Ethanol Dehydration Via Pervaporation

Thin-Film Composite Membrane Prepared by Interfacial Polymerization on the Integrated ZIF-L Nanosheets Interface for Pervaporation Dehydration

Second Interfacial Polymerization of Thin‐film Composite Hollow Fibers with Amine‐cyclodextrins for Pervaporation Dehydration

High pervaporation dehydration performance of the composite membrane with an ultrathin alginate/poly(acrylic acid)-Fe3O4 active layer

Thin-film composite membranes fabricated directly on a large-porous ceramic support using poly (4-styrenesulfonic acid) as a scaffold for ethanol dehydration

High-performance Polyamide/ceramic Hollow Fiber TFC Membranes with TiO2 Interlayer for Pervaporation Dehydration of Isopropanol Solution

Hollow fiber composite membranes of poly(paraterphenyl-3-bromo-1,1,1-trifluoroacetone) and PVA/glycine for ethanol dehydration

Efficient Pervaporation for Ethanol Dehydration: Ultrasonic Spraying Preparation of Polyvinyl Alcohol (pva)/ti3c2tx Nanosheet Mixed Matrix Membranes.

Enhanced Pervaporation Performance of SA-PFSA/ceramic Hybrid Membranes for Ethanol Dehydration

Improved pervaporation efficiency of thin-film composite polyamide membranes fabricated through acetone-assisted interfacial polymerization

High performance polyamide TFC reverse osmosis membrane fabricated on co-deposition hydrophilic modified polyethylene substrate

High performance composite membranes with a polycarbophil calcium transition layer for pervaporation dehydration of ethanol

Preparation and pervaporation performance of PVA membrane with biomimetic modified silica nanoparticles as coating

Study on High-Performance Pervaporation Desalination Membranes Prepared by Interfacial Reactions Between Two Aqueous Monomers

Designing High-Performance Pervaporation Membranes with Hierarchical Hydrophobic-Hydrophilic Coating Layers

Construction of High Performance Sulfonated Aromatic Block Copolymer/ptfe Composite Membrane for Pervaporation Desalination