Abstract:The pre-peak microstructure evolution of the material is crucial in determining the strength and failure scheme of the material, but is not captured by the existing shear strength parameters models which focus on post-peak stage information. Novel concepts of pseudo-cohesion and pseudo-internal friction angle that account for both the pre-peak and post-peak stage information were proposed in this study, based on the experimentally observed response of the rock mechanics parameters to an external load (the maximum principal stress). These two parameters were analytically derived as functions of maximum principal strain, with coefficients to be determined (i.e., by applying the Mohr–Coulomb criterion with these parameters to experimental data). The dependence of pseudo-cohesion and pseudo-internal friction angle on the axial strain and confining pressure was investigated. The evolution of the strength parameters was found to relate to the propagation of micro-crack developed in the loading process, as revealed by PFC 2D simulations reproducing experiments. The results show that (1) analytical model characterizing the pseudo-cohesion and internal friction angle as the quadratic function of axial strain accurately reflects the mechanical response characteristics of the specimen; (2) before the residual stage, the pseudo-cohesion first increases and then decreases with increasing strain, while the pseudo-internal friction angle increases continuously; (3) for the sandstone specimens studied, the pseudo-cohesion at the peak stress increases by a gradually decreasing rate with increasing confining pressure, while the pseudo-internal friction angle at the peak stress decreases by a decreasing rate with the increasing confining pressure; (4) CPM well characterized the mechanical properties of rock under multiple confining pressures, as the total stress–strain curves and failure modes of numerical specimens reproduced the experimental results. The evolution of rock pseudo-shear strength parameters is closely related to the external load and the generation, propagation, and penetration process of rock cracks. The rock pseudo-shear strength parameters are gradually mobilized with the increasing load, and the propagating of cracks owing to the decrease of mobilizable maximum cohesion and the increase of mobilizable maximum internal friction angle.

Influence of the microstructure on stress-dependent P -wave anisotropy in sandstone

DEM Analysis of the P-Wave Anisotropy Response to the Microstructure of Sedimentary Rock Under Biaxial Compression

Influence of bedding structure on stress-induced elastic wave anisotropy in tight sandstones

Research and analysis of the impact of the pore structure on the mechanical properties and fracture mechanism of sandstone

Anisotropic Mechanical Behavior of Stratified Sandstone Subjected to Cyclic Loading

Influence of moisture content and intermediate principal stress on cracking behavior of sandstone subjected to true triaxial unloading conditions

Study on the influence of pore water pressure on shear mechanical properties and fracture surface morphology of sandstone

Influence of Intermediate Principal Stress on Mechanical and Failure Properties of Anisotropic Sandstone

A novel obtaining method and mesoscopic mechanism of pseudo-shear strength parameter evolution of sandstone

The Influence of the Strain Rate and Prestatic Stress on the Dynamic Mechanical Properties of Sandstone—A Case Study from China

Assessment on anisotropy degree and fracture modes for weakly anisotropic sandstone using the acoustic emission technique

Nonlinear Mechanical and 3D Rupture Morphology of Saturated Porous Sandstone Under True Triaxial Stress

Micro-mechanical analysis of the effects of stress cycles on the dynamic and static mechanical properties of sandstone

Experimental Study on Dynamic Tensile Mechanical Behavior and Fracture Mechanical Characteristics of Sandstone with a Single Prefabricated Fissure

Stress wave propagation and dynamic behavior of red sandstone with single bonded planar joint at various angles

Understanding the effects of pore pressure–induced crack deformation on the acoustic anisotropy of rocks with aligned cracks

Stress‐induced anisotropy in Gulf of Mexico sandstones and the prediction of in situ stress

Insight into rock crack propagation from resistivity and ultrasonic wave variation

The Effect of Stress Anisotropy on Sanding: an Experimental Study

Study on the Meso-Structure Development in Direct Shear Tests of A Granular Material

Experimental study on the effective stress law and permeability of damaged sandstone under true triaxial stress