Abstract:Fourier transform infrared (FTIR) is a spectroscopy technique widely used to identify organic materials. It has recently gained popularity in microplastic (MP) pollution research to determine the chemical composition of unknown plastic fragments. However, it could also be used to evaluate the degree of ageing of MPs collected from the environment. In this context, the principal aim of our research has been to qualitatively evaluate the natural weathering of environmental MPs collected in an Italian freshwater body (the Ofanto River) using ATR-FTIR technology. Furthermore, we compared environmental particles to weathered artificial MPs under controlled light and temperature conditions and to unaltered pristine materials to assess the results. FTIR spectra were acquired using a Nicolet Summit FTIR (ThermoFisher Scientific) equipped with an Everest ATR with a diamond Crystal plate and a DTGS KBr detector (wavenumber range 4000-500 cm-1, 32 scans per spectrum, spectral resolution of 4 cm-1). The degree of ageing was assessed using three different indexes known to be related to changes in MPs: Carbonyl Index (CI), Hydroxyl Index (HI), and Carbon-Oxygen Index (COI). The overall results showed that the regions reflecting changes (hydroxyl groups, peaks from 3100 to 3700 cm-1, alkenes or carbon double bonds, 1600 and 1680 cm-1, and carbonyl groups, 1690 and 1810 cm-1) appeared significantly modified in artificial and natural weathered particles compared to the pristine materials. The indexes calculated for polymers degraded under the artificial photo and thermo ageing conditions displayed a general tendency to increase with the time in contact with irradiation time. Particular enhancements of CI of PS fragment and PE pellet, HI of PE and PS fragments and PE pellet, and COI of PS fragment were observed. Otherwise, the following incubation of the same particles at a constant temperature of 45 °C did not further affect the chemical composition of the particles. Moreover, new unique peaks were also observed in the freshwater particles, almost all in the fingerprint region (1500-500 cm-1). Differences in CI, HI, and COI were evidenced among the different morphological MP shapes. On the one hand, the CI calculated for the environmental PE pellets showed values ranging from 0.05 to 0.26 with a mean value of 0.17 ± 0.10. Most samples (57%) presented a CI with values between 0.16 and 0.30. On the other hand, fragments presented slicer modifications in the carbonyl region with CI values lower than pellets (0.05 ± 0.05). This index helps evaluate the degradation of PE MPs by UV light, increasing with enhancing residence time in the environment. Conversely, fragments showed greater values of HI (5.90 ± 2.57) and COI (1.04 ± 0.48) than pellets, as well as lines, which presented the maximum value of HI (11.51). HI is attributed to the bond vibrations of hydroxyl, carboxyl, or phenol groups. In contrast, COI is frequently attributed to the vibrations of C_O bonds found in carbohydrates, alkanes, secondary alcohols, and ketones. In conclusion, our results showed characteristics spectra acquired from environmental particles compared to pristine and artificial aged ones. The interpretation of our main results emphasizes the need to conduct ecotoxicological experimental studies using naturally weathered particles due to the unicity of their properties, which are more helpful for understanding microplastic pollution effects.

Comparison of ATR-FTIR and NIR spectroscopy for identification of microplastics in biosolids

FTIR and Raman Imaging for Microplastics Analysis: State of the Art, Challenges and Prospects

Identification and visualisation of microplastics by Raman mapping

Comparison of μ-ATR-FTIR spectroscopy and py-GCMS as identification tools for microplastic particles and fibers isolated from river sediments

Comparison of pyrolysis gas chromatography/mass spectrometry and hyperspectral FTIR imaging spectroscopy for the analysis of microplastics

What is the most effective analytical method for quantification and identification of microplastics in contaminated soils?

Identification of microplastics extracted from field soils amended with municipal biosolids

Identification and Characterization Methods for Microplastics Basing on Spatial Imaging in Micro-/Nanoscales

Investigation of new analysis methods for simultaneous and rapid identification of five different microplastics using ATR-FTIR spectroscopy and chemometrics

Contributions of Fourier transform infrared spectroscopy in microplastic pollution research: A review

Rapid on-site analysis of soil microplastics using miniaturized NIR spectrometers: Key aspect of instrumental variation

Vis-NIR spectroscopy based rapid and non-destructive method to quantitate microplastics: An emerging contaminant in farm soil

A method for the extraction of microplastics from solid biowastes including biosolids, compost, and soil for analysis by µ-FTIR

Comprehensive assessment of microplastics in Australian biosolids: Abundance, seasonal variation and potential transport to agroecosystems

Separation and Identification of Microplastics from Soil and Sewage Sludge.

Occurrence, spatiotemporal trends, fate, and treatment technologies for microplastics and organic contaminants in biosolids: A review

Efficient microplastic identification by hyperspectral imaging: A comparative study of spatial resolutions, spectral ranges and classification models to define an optimal analytical protocol

Fourier Transform Infrared Spectroscopy to Assess the Degree of Alteration of Artificially Aged and Environmentally Weathered Microplastics

Developing and testing a workflow to identify microplastics using near infrared hyperspectral imaging

Direct identification and visualisation of real-world contaminating microplastics using Raman spectral mapping with multivariate curve resolution-alternating least squares

Predicting soil microplastic concentration using vis-NIR spectroscopy