Abstract:Heavy metal ions such as hexavalent chromium (Cr(VI)) existed in wastewater have caused serious pollution problems. Cr(VI) is teratogenic and carcinogenic, while trivalent chromium (Cr(III)) is an essential nutrient for humans and animals. Adsorption method can transfer Cr(VI) from liquid phase to absorbent surface, but it needs follow-up treatment to remove Cr(VI). Photocatalysis technique can reduce Cr(VI) to Cr(III), so as to decrease its toxicity, but the adsorption capacity towards Cr(VI) is always small due to poor surface area of some traditional semiconductor oxide photocatalysts. Therefore, a new material with both good adsorption capacity and photocatalytic activity is needed for Cr(VI) removal. As an emerging kind of carbon materials, graphene oxide (GO) has attracted particular attention in the catalysis field. Graphene oxide aerogel (GOA), a three dimensional nanomaterial, possesses numerous adsorption sites and superior ability to accept and transport photogenerated electrons, would thus present good adsorption capacity and high photocatalytic performance simultaneously. So far, most studies on GO-base material are towards investigating its co-catalyst role (adsorption enhancement or electron shuttle) in improving efficiency of metal or semiconductor photocatalysts. Only a few studies have applied GO-base material as a sole photocatalyst. In this study, combined with the cross-linking method and the supercritical CO2 fluid extraction method, three-dimensional porous and recyclable GOA with large specific surface area and defect sites was prepared by using GO as the precursor. The physicochemical properties were characterized by SEM, XRD, Raman spectroscopy and nitrogen adsorption methods. The adsorption behavior and photocatalytic reduction performance of GOA towards Cr(VI) under visible light were investigated. GO was hydrothermally reduced during the preparation process. and many defects were generated on GO sheets. Melamine and cyanuric acid were used as crosslinking agents to increase the interlayer spacing. and at the same time providing GOA a large specific surface area and a rich porous structure. When the mass ratio of GO, melamine. and cyanuric acid was 3:3:3 and the GO concentration was 6 mg L-1, GOA exhibited the largest specific surface area and defect density. This kind of GOA, i.e., GOA(333)(-6) presented the best adsorption capacity and photocatalytic efficiency of Cr(VI). The adsorption behavior of GOA on Cr(VI) fits to the quasi-second-order kinetic model and the Langmuir adsorption isotherm model, indicating that the adsorption process was a single-layer chemical adsorption, in which the intra-particle diffusion in the initial adsorption stage was the rate-limiting step. The three-dimensional graphene oxide aerogel GOA obtained in this study exhibited large adsorption capacity, high photocatalytic removal efficiency for high concentration Cr(VI) under visible light, and good repeatability. Single GOA material has potential application in removing heavy metal ions from polluted wastewater.

Highly efficient and ultrafast removal of Cr(VI) in aqueous solution to ppb level by poly(allylamine hydrochloride) covalently cross-linked amino-modified graphene oxide

Graphene Oxide Decorated Nanoscale Iron Sulfide for Highly Efficient Scavenging of Hexavalent Chromium from Aqueous Solutions

Amino-assisted AHMT anchored on graphene oxide as high performance adsorbent for efficient removal of Cr(VI) and Hg(II) from aqueous solutions under wide pH range

Fabrication of graphene oxide decorated with poly(dimethyl amino ethyl methacrylate) brush for efficient Cr(VI) adsorption from aqueous solution

PEI grafted amino-functionalized graphene oxide nanosheets for ultrafast and high selectivity removal of Cr(VI) from aqueous solutions by adsorption combined with reduction: Behaviors and mechanisms

One-step synthesis of nitrogen-functionalized graphene aerogel for efficient removal of hexavalent chromium in water

High nitrogen content bimolecular co-functionalized graphene nanoflakes for hypertoxic Cr(VI) removal: Insights into adsorption behavior and mechanisms

Removal of Cr(VI) by ammonia-modified biomass adsorbent

Removal performance and mechanism of nano α-Fe2O3/graphene oxide on aqueous Cr(VI)

Enhanced adsorption-coupled reduction of hexavalent chromium by 2D poly(m-phenylenediamine)-functionalized reduction graphene oxide

Cr(VI) Removal from Aqueous Solution Using Chemically Reduced and Functionalized Graphene Oxide

Preparation of poly(allylamine hydrochloride) grafted porous boron nitride fibers for efficient Cr(VI) adsorption from aqueous solution

Effective Removal of Cr (VI) from Aqueous Solution by Reinforced Sodium Alginate/polyethyleneimine/graphene Oxide Composite Aerogels.

Enhanced Cr(VI) removal via CPBr-modified MIL-88A@amine-functionalized GO: synthesis, performance, and mechanism

Efficient removal of U(VI) from aqueous solution using poly(amidoxime-hydroxamic acid) functionalized graphene oxide

Amino-functionalized graphene oxide-supported networked Pd–Ag nanowires as highly efficient catalyst for reducing Cr(VI) in industrial effluent by formic acid

Rapid immobilization of Cr(VI) from aqueous waste through multi-functionalized surface-modified lignin-based aerogels: Dynamic and mechanism analyses

Efficient Removal of Hexavalent Chromium and Congo Red by Graphene Oxide/Silica Nanosheets with Multistage Pores

Ultra-high capacity and anti-interference for Cr(VI) removal by tannin-polyvinylimine modified graphite carbon nitride

High Efficient Adsorption and Photocatalytic Removal of Hexavalent Chromium over Three-Dimensional Grapheneoxide Aerogel under Visible Light

Synthesis, characterization, and adsorption capacity of sodium alginate poly grafted (fumaric acid-co-polyacrylic acid)/graphene oxide hydrogel as adsorbent for Cr (VI) and Pb (II) removal