Abstract:The measurement of 226 Ra and the identification of 226 Ra-bearing minerals are important for studying the behavior of radium in the environment. Various instruments for measuring 226 Ra are currently used: among the radiometric techniques that measure in bulk (no spatialization), there are gamma spectrometers and alpha spectrometers. Other instruments such as SEM-EDS can map the chemical elements thus providing information on the distribution of 226 Ra, but are limited for ultra-trace analyses on natural geomaterials. Finally, autoradiography techniques can locate radioactivity, but are limited to the identification of the contribution of 226 Ra when the 238 U series is complete. This study focuses on spectroscopic autoradiography, a method for measuring both the energy of the alpha particle emissions and their positions on the autoradiograph. A gas detector based on a parallel ionization multiplier technology was used for this purpose. Alpha particle energy is dependent on the emitting radionuclides. In order to track the 226 Ra, the energy spectrum of the 238 U series was studied with modeling software. It appears possible to apply a thresholding on the energy spectrum to discriminate the 226 Ra from the first alpha emitters of the 238 U decay chain (i.e. 238 U, 234 U and 230 Th, all below 5 MeV). The developed method was applied to a U-mill tailing sample prepared as a thin section. The sample was heterogeneous in terms of radioactivity and was not at secular equilibrium with 238 U, as expected. The 226 Ra was identified and localized, and different regions of interest were also analyzed with SEM-EDS elements cartography. This revealed 226 Ra-rich barite (BaSO4) phases measured at 3 ppm Ra on average and containing no uranium; and uranium in siderite (FeCO 3 ), showing a strong 226 Ra deficit compared with secular equilibrium. Spectroscopic autoradiography opens up possibilities for the analysis of heterogeneous geological samples containing natural alpha emitters such as 238 U and 226 Ra: the 226 Ra can be localized and quantified at ultra-trace content, and the method developed can also identify newly (young) uranium phases by measuring 238 U/ 226 Ra activity disequilibrium.

Determination of uranium and thorium isotopes in NORM materials in the ceramic industry by using alpha-particle spectrometry

Progress in AMS Measurement of U Isotope Ratios in Nanogram U Samples

Using spectroscopic autoradiography of alpha particles for the quantitative mapping of 226 Ra ultra-traces in geo-materials

A rapid dissolution procedure to aid initial nuclear forensics investigations of chemically refractory compounds and particles prior to gamma spectrometry

The worldwide NORM production and a fully automated gamma-ray spectrometer for their characterization

Use of combined solvent extraction-electrodeposition techniques to uranium and thorium isotopes analysis in industrial phosphoric acid, phosphate and phosphogypsum by alpha-particle spectrometry

Development of analytical method for zirconium determination in U–Pu–Zr alloy samples

Radioanalytical method for the separation of trace plutonium and neptunium from uranium

Determination of 239Pu, 241Am and 90Sr in urine using pre-filter material and combined sorbents AnaLig® Pu-02, AnaLig® Sr-01, DGA® Resin

Rapid and non-destructive determination of uranium and thorium by gamma spectrometry and a comparison with ICP-AES

Methods for tentative determination of presence of artificial nuclides in air using NuRMS EGS air sampler and WIMP 120 gross alpha/beta counter

Determination of 93Zr, 237Np and Th radionuclides in radioactive waste and mineral samples: extension of the method for determination of actinides

Determination of the 243 Cm/244 Cm ratio alpha spectrometry and spectral deconvolution in environmental samples exposed to discharges from the nuclear fuel cycle

A direct solid sampling electrothermal atomic absorption spectrometric method for determination of trace elements in zirconium dioxide

Development of a method to measure trace level of uranium and thorium in scintillation films

Evaluation of occupational exposure to naturally occurring radioactive materials in the Iranian ceramics industry

Development of an innovative external (in air) Particle Induced Gamma-ray Emission method for rapid non-destructive determination of isotopic composition of boron in "As received" boron based ceramic neutron absorbers

Determination of plutonium isotopes in environmental samples by extraction chromatography with triisooctylamine - polyethylene resin

Determination of analytes at trace level in uranium matrix by ICP-AES without chemical/physical separation

A simple method for Ce–Nd separation using nano-NaBiO3: Application in the isotopic analysis of U, Sr, Pb, Nd, and Hf in uranium ores

Determination of trace phosphorus in zirconium-niobium alloy and Zircaloy by UV-vis spectrophotometry