Asymmetric 3D Hole-Transporting Materials Based on Triphenylethylene for Perovskite Solar Cells
Jian Chen,Jianxing Xia,Hui-Juan Yu,Jun-Xing Zhong,Xiao-Kun Wu,Yuan-Shou Qin,Chunyang Jia,Zhigang She,Dai-Bin Kuang,Guang Shao
DOI: https://doi.org/10.1021/acs.chemmater.9b00702
IF: 10.508
2019-07-02
Chemistry of Materials
Abstract:Two asymmetric three-dimensional (3D) hole-transporting materials (HTMs) containing a triphenylethylene core and peripheral diphenylamine/triphenylamine moieties are first synthesized and successfully used in perovskite solar cells (PSCs). Both HTMs are obtained from facile preparation procedures and simple purification techniques. The X-ray diffraction, aggregation-induced emission properties, absorption and emission spectra, electrochemical properties, thermal stability, density functional theory calculations, hole mobility, scanning electronic microscopy, atomic force microscopy, steady-state and time-resolved photoluminescence, water contact angles, and photovoltaic parameters of the PSCs are compared. The highest power conversion efficiency increases from 12.57% (<b>CJ-02</b>) to 18.56% (<b>CJ-01</b>), rivaling that obtained from the state-of-the-art 2,2′,7,7′-tetrakis(<i>N</i>,<i>N</i>-di-<i>p</i>-methoxyphenylamine)-9,9′-spirobifluorene (spiro-OMeTAD) (18.69%). Further, the lab synthetic cost of <b>CJ-01</b> is only about 15.5% of the price of commercial spiro-OMeTAD, and the concentration of <b>CJ-01</b> solution for device fabrication is less than half of the concentration of spiro-OMeTAD solution (30.0 vs 72.3 mg mL<sup>–1</sup>). These results demonstrate that the propeller-shaped compounds with a highly twisted conformation are readily available and promising alternative HTMs for PSCs. Moreover, an applicable strategy to design new HTMs with 3D structure for achieving highly efficient PSCs is proposed.
materials science, multidisciplinary,chemistry, physical