Study of the structural, optical and electrical properties of PVA/SA performance by incorporating Al2O3 nanoparticles

DOI: https://doi.org/10.1007/s11082-024-06916-4

IF: 3

2024-05-10

Optical and Quantum Electronics

Abstract:Aluminum oxide nanoparticles (Al 2 O 3 NPs) were added to polyvinylpyrrolidone (PVP) and sodium alginate (SA) blend to synthesis nanocomposite films, using a solution casting technique, with favorable optical and electrical properties. The results reveal a series of noteworthy findings, where X-ray diffraction (XRD) measurement also shows that the addition of Al 2 O 3 NPs to PVP/SA blend caused a decrease in the crystallinity of the filled samples. Fourier infrared (FTIR) analysis showed prominent characteristic peaks corresponding to vibrational groups characterizing the prepared nanocomposite samples, which change randomly with increasing concentration of Al 2 O 3 NPs. Moreover, the indirect/direct optical energy gap decreased from 3.96/5.28 to 2.73/3.59 eV at 2.0 wt% of Al 2 O 3 NPs, confirming the improvement in the optical features of the doped samples, as evidenced by UV/Vis spectra. After adding the nanoparticles to the blend, AC electrical conductivity increased and showed to follows Jonscher's rule. The maximum value of AC conductivity observed at 2.0 wt% of Al 2 O 3 NPs in the blend is 1.445 10 − 6 S/cm. Additionally, the addition of the nanoparticles has been shown to increase in dielectric loss and dielectric constant of the composite samples. The improvement of the optical and electrical properties due to filling with Al 2 O 3 NPs indicates the possibility of using the prepared nanocomposites in optoelectronic devices. Also, studying the effect of incorporating Al 2 O 3 nanoparticles into PVP/SA blends has attracted little attention in the literature; therefore, this study is considered as a new research one.

engineering, electrical & electronic,optics,quantum science & technology