Experimental investigation of yaw-angle effects on drag reduction rate for trapezoidal riblets

Ayumu Inasawa,Ryo Taniguchi,Masahito Asai,Monami Sasamori,Mitsuru Kurita
DOI: https://doi.org/10.1007/s00348-024-03763-7
IF: 2.797
2024-02-17
Experiments in Fluids
Abstract:Effects of the yaw angle on the drag reduction rate of riblets were investigated experimentally for trapezoidal riblets with ridge angle of and height-to-spacing ratio of 0.5 in a turbulent wind channel at Reynolds numbers (based on the friction velocity and channel half depth) . Drag reduction rates were estimated carefully by comparing the streamwise pressure gradients between turbulent channel flows with and without riblets. The maximum drag reduction rate which was about 7% for the streamwise riblets was maintained without any attenuation for the yaw angle below . When exceeded , the drag reduction rate was attenuated steeply and the performance of riblets was almost lost at . The yaw angle at which the drag turned to increase was by 10o smaller than the value reported for the saw-tooth riblets. The yaw angle effect on the riblet performance was further examined by detailed comparisons of mean velocity profiles and turbulent structures near the ribbed surfaces for and . Although no appreciable difference in the turbulent intensity and pre-multiplied spectrum of near-wall turbulence was found between these cases ( and ), the mean velocity profile for the case of indicated an evidence of flow separation at the ridges of riblets, leading to the attenuation of drag-reduction rate due to increase in the pressure drag.
engineering, mechanical,mechanics
What problem does this paper attempt to address?